Fujitsu UTY-RNRUZ2 운영 매뉴얼 - 페이지 25
{카테고리_이름} Fujitsu UTY-RNRUZ2에 대한 운영 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Fujitsu UTY-RNRUZ2 26 페이지. Remote controller (wired type)
Fujitsu UTY-RNRUZ2에 대해서도 마찬가지입니다: 설치 매뉴얼 (11 페이지)
페이지 인쇄
4-4 Deadband and set temperature
The Cool and Heat set temperature difference at Custom
Auto cannot be less than the deadband set value. If the Cool
and Heat set temperature difference is the same as the
deadband set value, the Heat setting drops by the amount
of drop of the Cool setting and the Cool setting rises by the
amount of rise of the Heat setting. When the Cool set value
reaches the upper limit, Heat setting exceeding the dead-
band set value cannot be set.
4-5 Occupied state
In the following cases, the operation button needs to be
pressed twice:
• When stopping the operating indoor unit while "Unoccu-
pied" is displayed, press the operation button once to set
to "Occupied" and press it again to set to "Unoccupied".
Then the indoor unit stops.
• When operating the stopped indoor unit while "Occupied"
is displayed, press the operation button once to set to
"Unoccupied" and press it again to set to "Occupied".
Then the indoor unit operates.
In the following cases, the occupied state does not switch to
"Occupied" even if the indoor unit starts operation:
• Anti freeze operation
• Away operation
• Optimum start operation
5 OTHERS
5-1 Outline Dimensions
Unit: in (mm)
4-3/4(120)
All Fujitsu General products are manufactured to metric
units and tolerances. United States customary units are
provided for reference only.
In cases where exact dimensions and tolerances are
required, always refer to metric units.
13/16 (20.4)
5-2 Specifications
Model Name
Input voltage
Power consumption
Display
Usage temperature range
Usage humidity range
Storage temperature range
Storage humidity range
Dimensions
[H × W × D in (mm)]
Weight [oz (g)]
5-3 Error Code
For the details of the indoor unit or outdoor unit error when
checking the error contents, refer to the error codes in each
installation manual.
Error code
CC.1
Sensor error
C2.1
Transmission PCB error
12.1
Wired remote controller communication error
Number excess of device in wired remote controller
12.3
system
12.4
Wired remote controller system start-up error
Address duplication in wired remote controller sys-
26.4
tem
Address setting error in wired remote controller
26.5
system
15.4
Data acquisition error
UTY-RNRUZ2
DC 12 V
Max. 0.3 W
3.8 inch FSTN LCD display
(255 × 160 dots)
with Touch panel
32 to 104 °F (0 to 40 °C)
20 to 90 % (no condensation)
14 to 140 °F (-10 to 60 °C)
20 to 90 % (no condensation)
4-3/4 × 4-3/4 × 13/16
(120 × 120 × 20.4)
7.76 (220)
Contents
En-24