AEG 61300 지침서 - 페이지 36

{카테고리_이름} AEG 61300에 대한 지침서을 온라인으로 검색하거나 PDF를 다운로드하세요. AEG 61300 48 페이지. Washing machine
AEG 61300에 대해서도 마찬가지입니다: 지침서 (48 페이지)

Installation and Connection Instructions

INSTALLATION AND CONNECTION

INSTRUCTIONS

This appliance is heavy, care should be taken when moving it.

When moving, do not tip the washing machine onto its front or left

hand side (viewed from the front). This is to prevent the possibility of

electrical components becoming wet.

Before installation inspect the machine for transport damage. Do not

connect the appliance if it is damaged contact your retailer.

Ensure all packaging and transit bolts/bar have been removed, see

Removing of Transit Packaging. Failure to remove packaging and

transit bolt/bar may cause serious damage to the product or property.

Any plumbing work required to install this appliance should be car-

ried out by a qualified plumber or competent person.

Any electrical work required to install this appliance should be carried

out by a qualified electrician or competent person.

Check the electricity supply is the same as that indicated on the rat-

ing plate of the appliance.

Should the appliance mains cable need to be adapted for any reason

this should only be carried out by a qualified/competent person.

In the case of a permanent connection it is necessary that you install

a double pole switch between the appliance and the electricity supply

(mains), with a minimum gap of 3 mm between the switch contacts

and of a type suitable for the required load in compliance with the

electrical regulations.

The switch must not break the yellow and green earth cable at any

point.

Care must be taken to ensure that the appliance does not stand on

the electrical supply cable.

The installation must comply with local water authority and building

regulations requirements.

Appliances designed for cold water connection must not be con-

nected to hot water.