AEG 61300 지침서 - 페이지 43

{카테고리_이름} AEG 61300에 대한 지침서을 온라인으로 검색하거나 PDF를 다운로드하세요. AEG 61300 48 페이지. Washing machine
AEG 61300에 대해서도 마찬가지입니다: 지침서 (48 페이지)

Water Pressure

The appliance is designed to operate within the following water

pressure limits:

minimum 1 bar (14.5 p. s. i.)

maximum 10 bar (145 p. s. i.)

IMPORTANT!

At more than 10 bar (145 p. s. i.): Install pressure-reducing valve.

At less than 1 bar (14.5 p. s. i.): Unscrew the inlet hose from the appli-

ance at the inlet solenoid valve and remove the flow regulator (to do

this, remove the sieve with needle-nose pliers and remove rubber

washer behind the sieve). Replace sieve. Retain the washer for future

use.

The inlet hose provided is 1.2 or 1.3 metres depending on the model. If

a longer inlet hose is required contact your AEG Service Force Centre.

Under no circumstances should hoses be connected together to provide

a longer length.

The rubber washers are either set into the inlet hose threaded connec-

tion or supplied separately in the installation kit. These washers must be

fitted to ensure water tight seals. Do not use any other washer.

1. Connect the hose to the machine with

the right angled connector.

Important! Do not overtighten the plastic

nuts on the threaded connectors.

2. Connect the hose end with a straight

connector to the water supply tap with

an 3/4" thread.

Important! Do not overtighten the

plastic nuts on the inlet hose threaded

connectors.

WARNING!

Open the water taps slowly and check

the connections are watertight before

final positioning of the machine.

Installation and Connection Instructions

Rubber Washer

Fine Filter