Fujitsu E8210 - LifeBook - Core 2 Duo 1.66 GHz 바이오스 매뉴얼 - 페이지 11
{카테고리_이름} Fujitsu E8210 - LifeBook - Core 2 Duo 1.66 GHz에 대한 바이오스 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Fujitsu E8210 - LifeBook - Core 2 Duo 1.66 GHz 30 페이지. Windows vista addendum
Fujitsu E8210 - LifeBook - Core 2 Duo 1.66 GHz에 대해서도 마찬가지입니다: 사용 설명서 부록 (2 페이지)
페이지 인쇄
Serial/Parallel Port Configuration Submenu of the Advanced Menu
The Serial/Parallel Port Configuration submenu lets you
set the I/O addresses and interrupt levels for the serial,
infrared and parallel ports of your notebook.
I/O addresses, DMA channels and
Interrupt levels can be entered in various
ways, including via the BIOS setup utility,
the control software for the I/O device, or
the hardware. If any two ports or devices,
serial or parallel, have the same address
assigned, your notebook will not function
normally. Keep a record of original settings
before making any changes if restoration is
required. See your hardware and software
documentation as well as the setup utility
to determine settings and limitations.
Serial port:
Base I/O Address/IRQ: [3F8/IRQ 4]
Infrared Port:
Mode:
Base I/O Address/IRQ: [2E8 - 2EF]
DMA Channel:
Parallel Port:
Mode:
Base I/O Address:
Interrupt:
F1
Help
ESC
Exit
PhoenixBIOS Setup Utility
Advanced
Serial/Parallel Port Configurations
[Enabled]
[Enabled]
[FIR]
[DMA 3]
[Enabled]
[Bi-directional]
[378]
[IRQ 7]
Select Item
-/Space
Select Menu
Enter
Figure 5. Serial/Parallel Port Configuration Submenu
A d v a n c e d M e n u
To prevent IRQ and address conflicts,
■
avoid changing the default settings. If
you must change the settings, you can
call 1-800-8Fujitsu for technical assis-
tance.
■
If your notebook emits a series of beeps
that sounds like a code and the display is
blank, refer to the Troubleshooting Sec-
tion in the system User's Guide. The
Troubleshooting Section includes a list of
error messages and their meanings.
All I/O addresses in Table 5 are in hexa-
■
decimal.
Item Specific Help
[Disabled]
The port is disabled.
[Enabled]
The port is enabled
with user configuration.
[Auto]
Plug & Play OS
configure the port.
Change Values
F9
Select
Sub-Menu
F10
Setup Defaults
Save and Exit
11