Brother TD-4420TN 사용자 설명서 - 페이지 30

{카테고리_이름} Brother TD-4420TN에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Brother TD-4420TN 44 페이지. Cutter module
Brother TD-4420TN에 대해서도 마찬가지입니다: 설치 매뉴얼 (2 페이지)

페이지 인쇄

1. Troubleshooting

Power-On Utility

Function

1. Ribbon and Gap/Black Mark Sensors

calibration

2. Gap/Black Mark Sensor calibration,

self-test, and entering dump mode

3. Printer initialization

4. Media sensor calibration (For the Black

Mark Sensor)

5. Media sensor calibration (For the Gap

Sensor)

6. Skip the AUTO.BAS program

4.3.1 Ribbon and Gap/Black Mark Sensors Calibration

The Gap/Black Mark Sensor sensitivity should be calibrated when:

A new printer is purchased



Label stock is changed



Printer initialization takes place



To calibrate the ribbon and Gap/Black Mark Sensors:

1. Turn off the printer.

2. Press and hold the Feed/Pause Button, and then turn on the printer.

3. Release the button when the LED is flashing in red.

Note

The LED color will change as follows:



Amber  red (5 times)  amber (5 times)  green (5 times)  green/amber (5 times) 

red/amber (5 times)  green (lit)

To select the sensor for calibration, send the correct command to the printer:



For the Gap Sensor: send the GAP command



For the Black Mark Sensor: send the BLINE command



For more information about the available commands, see the FBPL Command Reference

Manual.

Amber

LED color

LED Patterns

Red

Amber

Green

(5 times)

Green/Amber

Red/Amber

(5 times)

Green (Lit)