AEG Automatic Refrigerator 사용 설명서 - 페이지 5

{카테고리_이름} AEG Automatic Refrigerator에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. AEG Automatic Refrigerator 10 페이지. Aeg automatic washing machines
AEG Automatic Refrigerator에 대해서도 마찬가지입니다: 사용 설명서 (11 페이지), 설치 및 연결 지침 (14 페이지)

페이지 인쇄

IMPORTANT!

If your new appliance has been bought to replace an

older model, please make the old appliance unusable

at once: pull the plug out of the socket, cut the

connecting lead off, and dispose of the plug together

with the remaining lead in an environmentally friendly

manner.

Any snap catch or lock on your old appliance should

also be made unusable before you put the appliance

away or hand it over to be disposed of in an environ-

mentally friendly manner.

In this way you can prevent children from locking them-

selves in when playing and thus endangering their lives.

Please make sure that the pipelines of your fridge-

freezer are not damaged before collection for envi-

ronment-friendly disposal.

Appliance packaging

information

All used materials are environmentally compatible!

They can be safely disposed of or burnt in a refuse

incinerator!

Regarding the materials: the plastics can also be

recycled and are marked as follows:

>PE< for polyethylene e.g. as used in the outer

wrapping and bags inside

>PS< for polystyrene foam e.g. as used in the

packing; this material is basically CFC-free

The cardboard parts are made of waste paper and

should be put back into the waste paper collection

system.

General instructions

You have just purchased a home refrigerator which

has been produced according to the standards appli-

cable to these appliances.

During manufacture, the necessary measures have

been taken as required by the Appliance Safety Act

(GSG), the Accident Prevention Regulations for Refrig-

erating Installations (VBG 20), and the Speciﬁ- cations

of the Institute of German Electrical Engi- neers (VDE).

The refrigeration circuit has been checked for

leakage.

This appliance complies with the following EC

Directives:

- 73/23/EEC of 19.02.1973 - Low-Voltage Directive

- 89/336/EEC of 03.05.1989 (including Amendment

Directive 92/31/EEC) - EMC (Electromagnetic

Compatibily) Directive.

Before starting up, we recommend you to read th

following Operating Instructions, since only by doing

so can you beneﬁt from all the advantages offered by

your refrigerator. These Operating Instruction are

intended for several technically comparable models

with different equipment. Please only follow the

instructions corresponding to your appliance version.

Removing the adhesive tapes

The door is secured to the housing with adhesive

tapes. Remove any adhesive tape residues with a

suitable petroleum-based cleansing agent.

Choice of location

Your refrigerator should be installed in a well venti-

lated, dry room. Never install your refrigerator near a

heater or oven or in direct sunlight.

Do not install in a room whose temperature may fall

below +16 C or exceed +32 C for any length of

time.

Your refrigerator should be installed on a ﬁrm, level

surface. Correct any ﬂoor irregularities by twisting the

adjustable feet in or out.

Commercial use

Should you use your home refrigerator commercially

or for purposes other than refrigeration of food and

drinks, you must observe the legal requirements

applicable to your area.

Your freezer needs air

Fig. 1

The refrigerating unit of your refrigerator is designed

for maintenance-free operation. What it should

never lack is good ventilation. Air is supplied under

the door through the ventilation slot between the

refrigerator and storage surface. Air is extracted

through the upper ventilation grille. Never obstruct

these openings by plinth screens or crockery.

If your refrigerator is installed under a continuous

worktop, an air outlet opening of at least 200 cm

and a ventilation grille (A/B) matching the worktop

design should be provided at the rear of the worktop

(Fig. 1). The cut surfaces of the worktop (C) should

be varnished to avoid swelling due to penetration of

moisture.

The appliance wall distance must be at least 30 mm

and should be checked before the ventilation grille is

inserted.