AEG AWF8024M3SB 사용자 설명서 - 페이지 35
{카테고리_이름} AEG AWF8024M3SB에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. AEG AWF8024M3SB 40 페이지.
페이지 인쇄
Fitting Hose Guide
1.
Pull apart to
insert hose.
2.
Adjust length to suit
trough.
In this case, make sure the end cannot
come unhooked when the machine will
be emptied. This could be done by tying
it to the tap with a piece of string or
attaching it to the wall.
Hose
bend
Guide
hose
pull hose
In a sink, drain pipe branch.
This branch must be above the trap so
that the bend is at least 60 cm above
the ground.
Max.
90 cm
Min.
60 cm
Push the drain hose onto the spigot
and secure with a clip, ensure a loop is
formed in the drain hose to prevent
waste from the sink entering the
appliance.
Directly into a drain pipe, at a height
of not less than 60 cm and not more
than 90 cm.
Max. 90 cm
Min. 60 cm
The end of the drain hose must always
be ventilated, i.e. the inside diameter
of the drain pipe must be larger than
the outside diameter of the drain hose.
The drain hose must not be twisted or
curled. Run it along the floor; only the
part near the drainage point must be
raised.
For the correct functioning of the
machine, the drain hose must remain
hooked on the proper support piece
situated on the top part of back side of
the appliance.
35