AEG AWF9024P5SB 사용자 설명서 - 페이지 31
{카테고리_이름} AEG AWF9024P5SB에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. AEG AWF9024P5SB 40 페이지.
페이지 인쇄Malfunction
Possible cause
The laundry is not evenly
distributed in the drum.
Machine
vibrates or
There is very little laundry in the
is noisy:
drum.
Unstable floors eg. wooden floors.
Detergent over dose.
Cycle time
longer than
displayed:
Machine unbalance.
The cycle is
shorter than
The appliance calculated a new time according to the laundry
the time
load.
displayed.
The electronic unbalance detection
device has cut in because the
laundry is not evenly distributed in
the drum. The laundry is
redistributed by reverse rotation of
Spinning
the drum.
starts late
This may happen several times
or machine
before the unbalance disappears
does
and normal spinning can resume. If,
not spin:
after 10 minutes, the laundry is still
not evenly distributed in the drum,
the machine will not spin. In this
case, redistribute the load manually
and select the spin program.
Machine not installed properly.
Machine
Transit bolts or packaging not
makes an
removed.
unusual
noise:
The load may be too small.
No water is
Machines based on modern technology operate very economical-
visible in
ly using very little water without affecting performance.
the drum:
Solution
Pause the machine and
redistribute laundry
manually.
Load more laundry.
Refer to relevant paragraph
in "Positioning" section.
Reduce the detergent
quantity or use another one.
(Refer page 22 "Detergents
Type And Quantity Of
Detergent").
Redistribute laundry
manually in the drum and
start the spin phase again.
Pause the machine and
redistribute laundry
manually.
Make sure the levelling of
the appliance is correct.
Refer to "Installation".
Make sure that the
packaging and/or the
transit bolts are removed.
Refer to "Unpacking".
Add more laundry in the
drum.
31