Fujitsu LifeBook C-6177 소프트웨어 설명서 - 페이지 5

{카테고리_이름} Fujitsu LifeBook C-6177에 대한 소프트웨어 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Fujitsu LifeBook C-6177 39 페이지. Bios setup utility

페이지 인쇄

1. Bios Setup Utility

Primary Master Submenu of the Main Menu

The Primary Master submenu identifies what ATA

devices are installed.

Main

Primary Master [TOSHIBA MK6014MAP-(PM)]*

Type:

Maximum Capacity:

Multi-Sector Transfers:

LBA Mode Control:

PIO Transfer Mode:

DMA Transfer Mode:

Help

ESC

Exit

Table 2: Fields, Options and Defaults for the Primary Master Submenu of the Main Menu

Menu Field

Options

Type:

Auto

None

CD-ROM

Hard Disk

Cylinders:

A number

between 0

and 65,535

Heads:

A number

between 1

and 16

Sectors:

A number

between 0

and 63

PhoenixBIOS Setup Utility

[Auto]

12073MB

[16 Sectors]

[Enabled]

[Fast PIO 4]

[Ultra DMA 2]

Select Item

-/Space

Select Menu

Enter

Figure 2 Primary Master Submenu

Default

[Auto]

–—

M a i n M e n u

* Actual hard drive label shown may vary. Depending on

the drive type, information such as cylinders, heads and

sectors may also be displayed.

Item Specific Help

Select ATA/ATAPI drive

installed here.

[Auto]

The BIOS auto-types the

drive on boot time.

Except [Auto]

You enter parameters of

the drive.

[None]

The drive is disabled.

Change Values

Select

Sub-Menu

F10

Description

Selects the ATA/ATAPI device type. Select Auto to have the type

automatically identified by the BIOS at POST. If None is selected, all

of the following Set-up items do not appear. Select CD-ROM if a

CD-ROM drive is installed at this connection. If Hard Disk is

selected, you must specify the number of Cylinders, Heads, and

Sectors for the drive.

This item appears only when Hard Disk is selected. When Hard Disk

is selected, you can change the value. This field is changed by

incrementing (pressing the [Spacebar]) or by typing in the number.

This item appears only when Hard Disk is selected. When Hard Disk

is selected, you can change the value. This field is changed by

incrementing (pressing the [Spacebar]) or by typing in the number.

This item appears only when Hard Disk is selected. When Hard Disk

is selected, you can change the value. This field is changed by

incrementing (pressing the [Spacebar]) or by typing in the number.

Setup Defaults

Save and Exit