Fujitsu LifeBook C-6631 바이오스 매뉴얼 - 페이지 6
{카테고리_이름} Fujitsu LifeBook C-6631에 대한 바이오스 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Fujitsu LifeBook C-6631 37 페이지. Bios setup utility
Fujitsu LifeBook C-6631에 대해서도 마찬가지입니다: 소프트웨어 설명서 (39 페이지)
페이지 인쇄
L i f e B o o k C S e r i e s B I O S
Primary Master Submenu of the Main Menu
The Primary Master submenu identifies what ATA
devices are installed.
Main
Type:
Maximum Capacity:
Multi-Sector Transfers:
LBA Mode Control:
PIO Transfer Mode:
DMA Transfer Mode:
F1
Help
ESC
Exit
Table 2: Fields, Options and Defaults for the Primary Master Submenu of the Main Menu
Menu Field
Options
Type:
Auto
n
None
n
CD-ROM
n
Hard Disk
n
Cylinders:
A number
n
between 0
and 65,535
Heads:
A number
n
between 1
and 16
Sectors:
A number
n
between 0
and 63
6
PhoenixBIOS Setup Utility
Primary Master [TOSHIBA MK2018GAP -(PM)]
[Auto]
20004MB
[16 Sectors]
[Enabled]
[Fast PIO 4]
[Ultra DMA 2]
Select Item
Select Menu
Figure 2. Primary Master Submenu
Default
[Auto]
–—
–—
–—
*Note that actual hard drive label shown may vary.
Depending on the drive type, information such as cylin-
ders, heads and sectors may also be displayed.
-/Space
Change Values
Enter
Select
Sub-Menu
Description
Selects the ATA/ATAPI device type. Select Auto to have the type
automatically identified by the BIOS at POST. If None is selected, all
of the following Set-up items do not appear. Select CD-ROM if a
CD-ROM drive is installed at this connection. If Hard Disk is
selected, you must specify the number of Cylinders, Heads, and
Sectors for the drive.
This item appears only when Hard Disk is selected. When Hard Disk
is selected, you can change the value. This field is changed by
incrementing (pressing the [Spacebar]) or by typing in the number.
This item appears only when Hard Disk is selected. When Hard Disk
is selected, you can change the value. This field is changed by
incrementing (pressing the [Spacebar]) or by typing in the number.
This item appears only when Hard Disk is selected. When Hard Disk
is selected, you can change the value. This field is changed by
incrementing (pressing the [Spacebar]) or by typing in the number.
Item Specific Help
Select ATA/ATAPI drive
installed here.
[Auto]
The BIOS auto-types the
drive on boot time.
Except [Auto]
You enter parameters of
the drive.
[None]
The drive is disabled.
F9
Setup Defaults
F10
Save and Exit