Fujitsu Lifebook C2310 바이오스 매뉴얼 - 페이지 6

{카테고리_이름} Fujitsu Lifebook C2310에 대한 바이오스 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Fujitsu Lifebook C2310 31 페이지. Lifebook c series
Fujitsu Lifebook C2310에 대해서도 마찬가지입니다: 소프트웨어 설명서 (39 페이지)

페이지 인쇄

L i f e B o o k C S e r i e s N o t e b o o k B I O S

Primary Master Submenu of the Main Menu

The Primary Master submenu identifies what ATA

devices are installed.

Main

Type:

Total Sectors:

Maximum Capacity:

Multi-Sector Transfers:

LBA Mode Control:

PIO Transfer Mode:

DMA Transfer Mode:

Help

ESC

Exit

Table 2: Fields, Options and Defaults for the Primary Master Submenu of the Main Menu

Menu Field

Options

Type:

• Auto

• None

• CD-ROM

• Hard Disk

CHS Format (Cylinders, Heads, Sectors)

Cylinders:

• A number

between 0

and 65,535

Heads:

• A number

between

1 and 16

PhoenixBIOS Setup Utility

Primary Master [IC25N040ATMR04-0-(PM)]

[Auto]

LBA Format

78140160

40008MB

[16 Sectors]

[Enabled]

[Multiword DMA 2]

[Disabled]

Select Item

Select Menu

Figure 2. Primary Master Submenu

Default

Description

[Auto]

Selects the ATA/ATAPI device type. Select Auto to have the type automati-

cally identified by the BIOS at POST. If None is selected, all of the following

Set-up items do not appear. Select CD-ROM if a CD-ROM drive is installed at

this connection. If Hard Disk is selected, you must specify the number of Cyl-

inders, Heads, and Sectors for the drive.

–—

This appears only when Hard Disk is selected. When Hard Disk is selected,

you can change the value. This field is incremented by pressing the [Space-

bar]). This field is decremented by pressing the [-] key. You can also change

the field by typing in the number.

–—

This appears only when Hard Disk is selected. When it is selected, you can

change the value. This field is incremented by pressing the [Spacebar]). This

field is decremented by pressing the [-] key. The field can also be changed by

typing in the number.

*Note that actual hard drive label shown may vary.

Depending on the drive type, information such as cylinders,

heads and sectors may also be displayed.

-/Space

Change Values

Enter

Select

Sub-Menu

Item Specific Help

Select ATA/ATAPI drive

installed here.

[Auto]

The BIOS auto-types the

drive on boot time.

Except [Auto]

You enter parameters of

the drive.

[None]

The drive is disabled.

Setup Defaults

F10

Save and Exit