AEG L 61271 BI 사용자 설명서 - 페이지 21

{카테고리_이름} AEG L 61271 BI에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. AEG L 61271 BI 36 페이지. Washing machines
AEG L 61271 BI에 대해서도 마찬가지입니다: 사용자 설명서 (36 페이지)

페이지 인쇄

12.7 Cleaning the inlet hose and the valve filter

Remove the inlet hose from the tap and clean

its internal valve.

Clean the valve filter on the back of the

appliance with a toothbrush.

12.8 Emergency emptying out

If the appliance does not drain the water,

proceed as follows:

1. Disconnect the mains plug from the

mains socket.

2. Close the water tap.

3. If necessary, wait until the water has

cooled down.

4. Place a bowl on the floor and put the

end of the emergency emptying

hose into the bowl. Remove its cap.

The water should drain into the bowl.

5. When the bowl is full, put the cap

back on the emergency hose.

6. Empty the bowl. Repeat the

procedure until water stops flowing.

Remove the inlet hose from the appliance by

loosening the ring nut.

20°

When you reconnect the hose to the back of

the appliance, do not turn the inlet hose

downwards, but turn it left or right depending

on the position of your water tap.

7. Clean the pump if necessary as

previously described ("Cleaning the

drain filter").

8. Ensure the cap is back on the

emergency emptying hose and insert

back into position.

When you drain the water with the

emergency drain procedure, you must

activate the drain system again:

1. Put 2 litres of water in the main wash

compartment of the detergent

dispenser.

2. Start the programme to drain the

water.

12.9 Frost precautions

If the appliance is installed in an area

where the temperature can be less than

ENGLISH

45°