Brother P-touch E550W 빠른 설정 매뉴얼 - 페이지 28

{카테고리_이름} Brother P-touch E550W에 대한 빠른 설정 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Brother P-touch E550W 48 페이지.

GETTING STARTED

Tape cassettes of 3.5 mm, 6 mm, 9 mm, 12 mm, 18 mm or 24 mm width, and Tube cassettes

of 5.8 mm, 8.8 mm, 11.7 mm, 17.7 mm or 23.6 mm width can be used in your P-touch.

If the new tape cassette has a cardboard stopper, be sure to remove the stopper

before inserting the cassette.

Check that the end of the tape is not bent and that it passes

through the tape guide. If the tape is not passed through, pass it

through the tape guide as shown in the illustration.

1. End of tape

2. Tape guide

After making sure that the power is off, place the P-touch on

a flat surface as shown in the illustration, and then open the

rear cover. If there is already a tape cassette in the P-touch,

remove it by pulling it straight up.

Insert the tape cassette into the tape compartment,

with the end of the tape facing the P-touch tape exit slot,

and press firmly until you hear a click.

1. Tape exit slot

• When inserting the tape cassette, make sure that the tape and ink ribbon do not catch on

the print head.

• Make sure that there is no slack in the tape, and then

carefully insert the tape cassette. If there is slack in the

tape, the tape will catch on the protrusion (2) when the

cassette is inserted and become bent or wrinkled, causing

the tape to jam.

To fix the slack in the tape, refer to the illustration in step

1 and pull the tape outside of the tape guide.

• When removing the tape cassette, make sure that the tape does not catch on the

protrusion (2).

Inserting a Tape Cassette