Fujitsu LIFEBOOK E Series 사용자 설명서 - 페이지 24

{카테고리_이름} Fujitsu LIFEBOOK E Series에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Fujitsu LIFEBOOK E Series 34 페이지.
Fujitsu LIFEBOOK E Series에 대해서도 마찬가지입니다: 쉬운 매뉴얼 (41 페이지)

페이지 인쇄

Wireless LAN.book Page 22 Wednesday, November 28, 2001 11:30 AM

I n t e g r a t e d W i r e l e s s L A N U s e r ' s G u i d e

Problem

Possible Cause

Cannot connect to

There are several

the network

possible causes, as

listed to the right.

Refer to the

specific section of

this manual or your

user's manual.

I want to remove

the driver.

(Windows 98)

Possible Solution

The following causes are possible. Check each one of them.

The network name or encryption key is not right.

The driver has not correctly started.

The destination computer is not turned on.

You do not have the access privilege to the destination

computer.

The card has failed.

Hardware conflict.

Windows 98:

When removing the driver, make sure that the device is

attached to the computer. If you try to remove the driver

while the device is detached from the computer, the driver is

not removed.

1. Right click the [My Computer] icon on the desktop, and

then click [Properties] from the menu that appears.

[System Properties] appears.

2. Click the [Device Manager] tab.

3. Click [+] beside [Network adapters].

4. Perform the following steps.

Click [Intersil PRISM Wireless LAN PCI Card].

Click [Remove]. [Confirm Device Removal] appears.

5. Click [OK]. The device is removed, and [System Settings

Change] appears.

6. Click [No].

7. Close [System Properties].

8. Make sure that the icon has disappeared from the task

tray in the lower right corner of the screen.

9. Click [Start] -> [Settings] -> [Control Panel]. [Control

Panel] appears.

10. Double-click [Add/Remove Programs]. [Add/Remove

Programs Properties] appears.

11. Double-click [PRISM 11Mbps Wireless LAN for

Windows]. A window appears asking you if you really

want to remove the driver.

12. Click [Yes]. When the driver is removed, a window

appears showing that the driver has been removed.

13. Click [OK].

14. Close [Add/Remove Programs Properties] and [Control

Panel].

15. Shut down Windows, and turn off the computer.