Fujitsu Lifebook E-6664 바이오스 매뉴얼 - 페이지 12

{카테고리_이름} Fujitsu Lifebook E-6664에 대한 바이오스 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Fujitsu Lifebook E-6664 33 페이지. Lifebook e series

Fujitsu Lifebook E-6664 바이오스 매뉴얼
L i f e B o o k E S e r i e s B I O S
Serial/Parallel Port Configuration Submenu of the Advanced Menu
The Serial/Parallel Port Configuration submenu
provides the ability to set the I/O addresses and
interrupt levels for the serial, infrared and parallel
ports of your notebook.
C A U T I O N
I/O addresses, DMA channels and Interrupt levels
can be entered in various ways, including via the BIOS
setup utility, the control software for the I/O device,
or the hardware. If any two ports or devices, serial or
parallel, have the same I/O address assigned your
notebook will not function normally. Please keep a
record of original settings before making any changes
in the event that a restoration is required. See your
hardware and software documentation as well as the
setup utility to determine settings, limitations, etc.
Serial port:
I/O Address:
Interrupt:
Infrared Port:
Mode:
I/O Address:
Interrupt:
I/O Address:
DMA Channel:
Parallel Port:
Mode:
I/O Address:
Interrupt:
F1
Help
ESC
Exit
12
PhoenixBIOS Setup Utility
Advanced
Serial/Parallel Port Configurations
[Enabled]
[3F8 - 3FF]
[IRQ 4]
[Enabled]
[FIR]
[2E8 - 2EF]
[IRQ 3]
[400-43F]
[DMA 3]
[Enabled]
[Bi-directional]
[378 - 37F]
[IRQ 7]
Select Item
-/Space
Select Menu
Enter
Figure 5. Serial/Parallel Port Configuration Submenu
P O I N T S
To prevent IRQ and address conflicts, avoid changing
the default settings. If you must change the settings,
you can call 1-800-8FUJITSU for technical assistance.
If your notebook emits a series of beeps that sounds
like a code and the display is blank, please refer to the
Troubleshooting Section. The Troubleshooting Section
includes a list of error messages and their meanings.
All I/O addresses in Table 5 are in hexadecimal.
Item Specific Help
[Disabled]
The port is disabled.
[Enabled]
The port is enabled
with user configuration.
[Auto]
The port is configured
depending on 'Plug &
Play OS' setting.
Change Values
F9
Select
Sub-Menu
F10
Setup Defaults
Save and Exit