Fujitsu Lifebook I4177 바이오스 매뉴얼 - 페이지 8
{카테고리_이름} Fujitsu Lifebook I4177에 대한 바이오스 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Fujitsu Lifebook I4177 37 페이지. Fujitsu laptop pc bios guide
L i f e B o o k i S e r i e s B I O S
Primary Slave Submenu of the Main Menu
The Primary Slave submenu is for the internal CD-ROM
drive. The drive type is displayed on this menu as well as
the Main menu. Your notebook auto-senses the charac-
teristics of the internal CD-ROM Drive installed.
Main
Primary Slave [TOSHIBA DVD-ROM SD-C2402-(PS)]
Type:
Multi-Sector Transfers:
LBA Mode Control:
PIO Transfer Mode:
DMA Transfer Mode:
F1
Help
ESC
Exit
Table 3: Fields, Options and Defaults for the Primary Slave Submenu of the Main Menu
Menu Field
Options
Type:
Auto
None
CD-ROM
Hard Disk
Cylinders:
A number
between 0
and 65,535
Heads:
A number
between 1
and 16
Sectors:
A number
between 0
and 63
8
PhoenixBIOS Setup Utility
[Auto]
[Disabled]
[Disabled]
[Fast PIO 4]
[Ultra DMA 2]
Select Item
-/Space
Select Menu
Enter
Figure 3. Primary Slave Submenu
Default
[Auto]
–—
–—
–—
Note that, although Auto is the default setting for this
submenu, the Hard Disk setting is illustrated, since it
contains all of the menu fields.
The actual hard drive label shown may vary.
Item Specific Help
Select ATA/ATAPI drive
installed here.
[Auto]
The BIOS auto-types the
drive on boot time.
Except [Auto]
You enter parameters of
the drive.
[None]
The drive is disabled.
Change Values
F9
Select
Sub-Menu
F10
Description
Selects the ATA/ATAPI device type. Select Auto to have the type
automatically identified by the BIOS at POST. If None is selected, all
of the following Set-up items do not appear. Select CD-ROM or
Hard Disk for appropriate drive type installed at this connection.
This item appears only when Hard Disk is selected. When Hard Disk
is selected, you can change the value. This field is changed by
incrementing (pressing the [Spacebar]) or by typing in the number.
This item appears only when Hard Disk is selected. When Hard Disk
is selected, you can change the value. This field is changed by
incrementing (pressing the [Spacebar]) or by typing in the number.
This item appears only when Hard Disk is selected. When Hard Disk
is selected, you can change the value. This field is changed by
incrementing (pressing the [Spacebar]) or by typing in the number.
Setup Defaults
Save and Exit