AEG L 7347 FL 사용자 설명서 - 페이지 23
{카테고리_이름} AEG L 7347 FL에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. AEG L 7347 FL 28 페이지.
페이지 인쇄
Problem
The appliance fills
with water and drain
immediately.
The cycle is shorter
than the time dis-
played.
The cycle is longer
than the time dis-
played.
The washing results
are not satisfactory.
After the check, activate the appliance.
The programme continues from the
point of interruption.
If the problem occurs again, contact the
Service.
13. TECHNICAL DATA
Dimensions
Electrical connection:
Level of protection against ingress of solid particles
and moisture ensured by the protective cover, ex-
cept where the low voltage equipment has no pro-
tection against moisture
Water supply pressure
Water supply
Maximum load
Spin speed
1) Connect the water inlet hose to a water tap with a 3/4'' thread.
Possible solution
Make sure that the drain hose is in the correct position.
The hose may be too low.
The appliance calculates a new time according to the
laundry load. See the 'Consumption Values' chapter.
An unbalanced laundry load increases the duration
time. This is a normal behavior of the appliance.
Increase the detergent quantity or use a different de-
tergent.
Use special products to remove the stubborn stains be-
fore you wash the laundry.
Make sure that you set the correct temperature.
Decrease the laundry load.
Width / Height / Depth
Total depth
Voltage
Overall power
Fuse
Frequency
Minimum
Maximum
1)
Cotton
Maximum
If the display shows other alarm codes.
Deactivate and activate the appliance. If
the problem continues, contact the Serv-
ice.
ENGLISH
23
600 / 850 / 522 mm
540 mm
230 V
2200 W
10 A
50 Hz
IPX4
0,5 bar (0,05 MPa)
8 bar (0,8 MPa)
Cold water
7 kg
1400 rpm