AEG L 74484 WVFL 사용자 설명서 - 페이지 4

{카테고리_이름} AEG L 74484 WVFL에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. AEG L 74484 WVFL 28 페이지.

페이지 인쇄

www.aeg.com

If the supply cord is damaged, it must be replaced by

•

the manufacturer, its Authorised Service Centre or

similarly qualified persons in order to avoid a hazard.

Before maintenance, deactivate the appliance and

•

disconnect the mains plug from the mains socket.

Do not use water spray and steam to clean the

•

appliance.

Clean the appliance with a moist soft cloth. Only use

•

neutral detergents. Do not use abrasive products,

abrasive cleaning pads, solvents or metal objects.

If a tumble dryer is stacked on the top of the washing

•

machine, make sure to use the correct stacking kit

approved by AEG (see more details in chapter

"Accessories - Stacking kit").

2. SAFETY INSTRUCTIONS

2.1 Installation

• Remove all the packaging and the

transit bolts.

• Keep the transit bolts. When you

move the appliance again you must

block the drum.

• Always be careful when you move the

appliance because it is heavy. Always

wear safety gloves.

• Do not install or use a damaged

appliance.

• Obey the installation instruction

supplied with the appliance.

• Do not install or use the appliance

where the temperature is less than 0

°C or where it is exposed to the

weather.

• Make sure that the floor where you

install the appliance is flat, stable,

heat resistant and clean.

• Make sure that there is air circulation

between the appliance and the floor.

• Adjust the feet to have the necessary

space between the appliance and the

carpet.

• Do not install the appliance where the

appliance door can not be fully

opened.

2.2 Electrical connection

• The appliance must be earthed.

• Always use a correctly installed

shockproof socket.

• Make sure that the electrical

information on the rating plate agrees

with the power supply. If not, contact

an electrician.

• Do not use multi-plug adapters and

extension cables.

• Make sure not to cause damage to

the mains plug and to the mains

cable. Should the mains cable need

to be replaced, this must be carried

out by our Authorised Service Centre.

• Connect the mains plug to the mains

socket only at the end of the

installation. Make sure that there is

access to the mains plug after the

installation.

• Do not touch the mains cable or the

mains plug with wet hands.

• Do not pull the mains cable to

disconnect the appliance. Always pull

the mains plug.

• Only for UK and Ireland: The

appliance has a 13 A mains plug. If it

is necessary to change the fuse in the

mains plug, use a 13 A ASTA (BS

1362) fuse.