Fujitsu Lifebook NH751 바이오스 매뉴얼 - 페이지 13
{카테고리_이름} Fujitsu Lifebook NH751에 대한 바이오스 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Fujitsu Lifebook NH751 14 페이지. Lifebook n series
Fujitsu Lifebook NH751에 대해서도 마찬가지입니다: 데이터시트 (2 페이지), 시작하기 (13 페이지)
페이지 인쇄
EXIT MENU – LEAVING THE SETUP UTILITY
The Exit Menu is used to leave the setup utility. Follow
the instructions for Navigating Through the Setup
Utility to make any changes. (See Navigating through
the Setup Utility on page 2 for more information.)
Info
Exit Saving Changes
Exit Discarding Changes
Load Setup Defaults
Discard Changes
Save Changes
Save Changes and Power Off
F1
Help
ESC
Exit
Table 8: Fields, Options and Defaults for the Exit Menu
Menu Field
Description
Exit Saving
Exit Saving Changes and Exit will store all the entries on every menu of the setup utility to the BIOS memory, then exit
Changes
the utility. A confirmation message Save Configuration changes and exit now? [Yes][No] is displayed.
Exit Discarding
Selecting Exit Discarding Changes and Exit will exit the setup utility with out writing to the BIOS memory. When the
Changes
BIOS recognizes this selection it will load the operating system and begin operation.
Load Setup
Selecting Load Setup Defaults will load the factory preset default values for all menu fields, then display the message
Defaults
Load default configuration now? [Yes] [No]. When confirmed the setup utility will return to the Exit
Menu. To return to another menu follow the directions in the Navigating Through the Setup Utility Section.
Discard
Selecting Discard Changes will load the previous values in BIOS memory for all menu fields. The message Load
Changes
previous configuration now? [Yes] [No] will be displayed. When confirmed the setup utility will return to
the Exit menu. To return to another menu, follow the directions in the Navigating Through the Setup Utility Section.
Save Changes
Selecting Save Changes will cause the new settings in all menus to be written to the BIOS memory. The message Save
configuration changes now? [Yes] [No] will be displayed. When confirmed, the setup utility will return to
the Exit menu. To return to another menu, follow the directions in the Navigating Through the Setup Utility section.
Save Changes
Selecting Save Changes and Power Off will cause the new settings in all menus to be written to the BIOS memory. The
and Power Off
message Save configuration changes and power off now? [Yes] [No] will be displayed. When con-
firmed, the system will shut down. If No is selected, the system will return to the Exit menu. To return to another menu,
follow the directions in the Navigating Through the Setup Utility section.
Phoenix SecureCore(tm) Setup Utility
System
Advanced
Select Item
-/Space
Select Menu
Enter
Figure 8. Exit Menu
The following table shows the names of the menu fields
for the Exit menu, the default settings and a description
of the field's function and any special information
needed to help understand the field's use.
Security
Boot
Exit
Exit System Setup and
save your changes to
CMOS.
Change Values
Select
Sub-Menu
E x i t M e n u
Item Specific Help
F9
Setup Defaults
F10
Save and Exit
13