Fujitsu Lifebook P1510D 쉬운 매뉴얼 - 페이지 31

{카테고리_이름} Fujitsu Lifebook P1510D에 대한 쉬운 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Fujitsu Lifebook P1510D 37 페이지. P series
Fujitsu Lifebook P1510D에 대해서도 마찬가지입니다: 바이오스 매뉴얼 (26 페이지)

페이지 인쇄

1. Notes on Installing and Removing Boards and Components

Removing and installing memory modules

Mainmemory

System expansion

Memoryupgrade

Memoryexpansion

The installation and removal of memory modules in one of the two slots

should only be carried out by an authorised technician.

The notebook will not start without memory modules, as no ﬁxed RAM is installed.

Your notebook supports dual channel DDR3 technology.

The dual channel DDR3 technology can only be used with two identical memory

modules. When two different memory modules are installed, only "single channel"

mode is supported. This reduces the performance of your notebook.

With a memory conﬁguration of 4 GBytes, the visible and usable

main memory may be reduced to 3 GBytes (depending on notebook

conﬁguration and the operating system used).

If you are asked by the Hotline/Help Desk to remove and install the memory

modules yourself, proceed as follows:

Pay attention to the relevant safety notes provided in the "Important notes" chapter.

The notebook must be switched off when installing/removing the memory

modules, it must not be in Suspend mode.

Only use approved memory expansion modules in your notebook

(see Section

Never use force when installing or removing memory modules.

Make sure that foreign objects do not fall into the memory expansion compartment.

Individual components (e.g. the processor heat sink) can become very hot

during operation. Therefore, we recommend that you wait one hour after

switching off the notebook before removing or installing the memory modules.

Otherwise, there is a risk of suffering burns!

As some non-ESD safe components are exposed, please observe the section

on installing and removing boards and components", Page

► Switch your notebook off and unplug the mains adapter from the mains outlet.

► Close the LCD screen.

► Disconnect all cables connected to the notebook.

► Turn your notebook over and place it on a stable, ﬂat and clean surface. If necessary, lay

an anti-slip cloth on this surface to prevent the notebook from being scratched.

► Remove the battery (see

A26391-K212-Z220-1-7619, edition 1

Removing and installing components during servicing

"Technical data", Page

"Removing the battery", Page

26).

15).

"Notes

22.