AEG L 76285 FL 사용자 설명서 - 페이지 24
{카테고리_이름} AEG L 76285 FL에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. AEG L 76285 FL 36 페이지. Washing machine
AEG L 76285 FL에 대해서도 마찬가지입니다: 사용자 설명서 (32 페이지), 사용자 설명서 (28 페이지)
페이지 인쇄
24 www.aeg.com
Put the drainage duct back and close the
drain pump flap.
When you drain the water with the emer-
gency drain procedure, you must acti-
vate again the drain system:
1.
Put 2 litres of water in the main wash
compartment of the detergent dis-
penser.
2.
Start the programme to drain the
water.
11.10 Frost precautions
If the appliance is installed in an area
where the temperature can be less than
0 °C, remove the remaining water from
the inlet hose and the drain pump.
1.
Disconnect the mains plug from the
mains socket.
12. TROUBLESHOOTING
The start of the appliance does not oc-
cur or it stops during operation.
First try to find a solution to the problem
(refer to the table). If not, contact the
service centre.
With some problems, the acoustic
signals operate and the display shows
an alarm code:
•
- The appliance does not fill with
water.
Problem
The appliance
does not fill with
water.
Possible cause
The water tap is closed.
The water inlet hose is
damaged.
The filters in the water
inlet hose is blocked .
The water tap is blocked
or is furred with lime-
scale.
The connection of the
water inlet hose is not
correct.
The water pressure is
too low.
2.
Close the water tap.
3.
Remove the water inlet hose
4.
Put the two ends of the inlet hose in
a container and let the water flow
out of the hose.
5.
Empty the drain pump. Refer to the
emergency drain procedure
6.
When the drain pump is empty, in-
stall the inlet hose again.
WARNING!
Make sure that the temperature
is more than 0 °C before you use
the appliance again.
The manufacturer is not responsi-
ble for damages caused by low
temperatures.
•
- The appliance does not drain
the water.
•
- The appliance door is open or
not closed correctly.
•
- The anti-flood device is on.
WARNING!
Deactivate the appliance before
you do the checks.
Possible solution
Open the water tap.
Make sure that the water inlet
hose has no damages.
Clean the filters. Refer to 'Care
and cleaning'.
Clean the water tap.
Make sure that the connection
is correct.
Contact your local water author-
ity.