AEG L 76475 FL 사용자 설명서 - 페이지 25

{카테고리_이름} AEG L 76475 FL에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. AEG L 76475 FL 32 페이지.
AEG L 76475 FL에 대해서도 마찬가지입니다: 사용자 설명서 (2 페이지)

페이지 인쇄

Problem

You cannot open

the appliance

door.

The appliance

makes an unusual

noise.

The appliance fills

with water and

drain immediately.

The washing re-

sults are not satis-

factory.

After the check, activate the appliance.

The programme continues from the

point of interruption.

If the problem occurs again, contact the

service centre.

13. INSTALLATION

13.1 Fixing plate kit

(405517114)

Available from your authorized dealer.

Possible cause

Leakages from the drain

pump.

The water drain hose is

damaged.

The washing pro-

gramme is in operation.

There is water in the

drum.

Incorrect level of the ap-

pliance.

You did not remove the

packaging and/or the

transit bolts.

The load is very small.

The end of the drain

hose is too low.

The detergent you used

was not sufficient or cor-

rect.

You did not remove the

stubborn stains before

you wash the laundry.

Incorrect temperature

was set.

Too much laundry load.

Possible solution

Make sure that the drain pump

filter is tight.

Make sure that the water inlet

hose has no damages.

Let the washing programme

end.

Set the drain or the spin pro-

gramme.

Adjust the level of the appli-

ance. Refer to 'Installation'.

Remove the packaging and/or

the transit bolts. Refer to 'Instal-

lation'.

Add more laundry in the drum.

Make sure that the drain hose is

in the correct position.

Increase the detergent quantity

or use a different one.

Use special products to remove

the stubborn stains.

Make sure that you set the cor-

rect temperature.

Decrease the laundry load.

If the display shows other alarm codes,

contact the service centre.

If you install the appliance on a plinth,

secure the appliance in the fixing plates.

Follow the instructions supplied with the

kit.

ENGLISH