AEG L 76479 WFLC 사용자 설명서 - 페이지 18
{카테고리_이름} AEG L 76479 WFLC에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. AEG L 76479 WFLC 28 페이지.
페이지 인쇄18
www.aeg.com
10.10 Interrupting a
programme and changing a
option
You can change only some options
before they operate.
1. Press button Start/Pauza.
The related indicator flashes.
2. Change the option set.
3. Press the button Start/Pauza again.
The programme continues.
10.11 Cancelling a running
programme
1. Press button Zap/Vyp to cancel the
programme and to deactivate the
appliance.
2. Press button Zap/Vyp again to
activate the appliance.
Now, you can set a new washing
programme.
Before starting the new
programme the appliance
could drain the water. In this
case, make sure that the
detergent is still in the
detergent compartment, if
not fill the detergent again.
10.12 Opening the door
If the temperature and level
of the water in the drum are
too high and/or the drum
still rotates you cannot open
the door.
While a programme or the delay start
operates, the appliance door is locked.
1. Press button Start/Pauza.
In the display the related door lock
indicator goes off.
2. Open the appliance door.
3. Close the door and press button
Start/Pauza.
The programme or the delay start
continues.
10.13 End of cycle
When the programme has finished, the
appliance stops automatically. The
acoustic signal operates (if it is active).
In the display
comes on and the door
locked indicator
The indicator of Start/Pauza button goes
off.
1. Press button Zap/Vyp to deactivate
the appliance.
After five minutes from the end of the
programme, the energy saving function
automatically deactivates the appliance.
When you activate the
appliance again, the display
show the end of the last set
programme. Turn the
programme knob to set a
new cycle.
2. Remove the laundry from the
appliance.
3. Make sure that the drum is empty.
4. Keep the door ajar, to prevent
mildew and odours
10.14 Draining water out after
end of cycle
The washing programme is completed,
but there is water in the drum:
The drum turns regularly to prevent the
creases in the laundry.
The door lock indicator
door stays locked.
You must drain the water to open the
door:
1. If necessary, decrease the spin
speed.
2. Press the Start/Pauza button.
The appliance drains the water and
spins.
3. When the programme is completed
and the door lock indicator
off, you can open the door .
4. Press Zap/Vyp some seconds to
deactivate the appliance.
The appliance drains and
spins automatically after
approximately18 hours.
goes off.
is on. The
goes