AEG L 77685 WD 사용자 설명서 - 페이지 30
{카테고리_이름} AEG L 77685 WD에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. AEG L 77685 WD 40 페이지.
AEG L 77685 WD에 대해서도 마찬가지입니다: 사용자 설명서 (36 페이지)
30 www.aeg.com
Problem
The programme
does not start.
There is water on
the floor.
You cannot open
the appliance
door.
The appliance
makes an unusual
noise.
The appliance fills
with water and
drain immediately.
The cycle is short-
er than the time
displayed.
Possible cause
The filter of the drain
pump is blocked.
Balance problems with
the laundry load.
The mains plug is not
connected in the mains
socket.
Blow out fuse in the
household fuse box.
You did not press but-
ton
4
.
The delay start is set.
The Child Lock function
is activated.
Leakages from the cou-
plings of the water ho-
ses.
Leakages from the drain
pump.
The water drain hose is
damaged.
The washing pro-
gramme is in operation.
There is water in the
drum.
Incorrect level of the ap-
pliance.
You did not remove the
packaging and/or the
transit bolts.
The load is very small.
The end of the drain
hose is too low.
The appliance calculates
a new time according to
the laundry load.
Possible solution
Clean the filter of the drain
pump. Refer to 'Care and clean-
ing'.
Adjust manually the items in the
tub and start the spin phase
again.
Put in the mains plug.
Replace the fuse.
Press button
4
.
To start immediately the pro-
gramme, cancel the delay start.
Deactivate the Child Lock func-
tion.
Make sure that the couplings
are tight.
Make sure that the drain pump
filter is tight.
Make sure that the water inlet
hose has no damages.
Let the washing programme
end.
Set the drain or the spin pro-
gramme.
Adjust the level of the appli-
ance. Refer to 'Installation'.
Remove the packaging and/or
the transit bolts. Refer to 'Instal-
lation'.
Add more laundry in the drum.
Make sure that the drain hose is
in the correct position.
See the 'Consumption Values'
chapter.