Brother PT-D460BT 빠른 시작 매뉴얼 - 페이지 3
{카테고리_이름} Brother PT-D460BT에 대한 빠른 시작 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Brother PT-D460BT 9 페이지.
Brother PT-D460BT에 대해서도 마찬가지입니다: 매뉴얼 (9 페이지)
페이지 인쇄
Before Use
1. Overview
Tape Viewer
Tape Cutter
Lever
Tape Exit Slot
Power
Keyboard
Starter
Tape Cassette
USB Cable
AC Adapter
The components included in the box may differ depending on your country or region.
Serial Number Location
Serial Number
Application Download Label
AC Adapter Jack
USB Port
D460BT
Tape Cassette
Compartment
Cover
Preview
LCD
1
2 3 4 5 6 7
8
9
10
11
12
1. Caps mode
2-7. Font Style Icons
8. Label Width x Label Length
9. Block number
10. Line number
11. Cursor
12. Return mark
2. Install Batteries or Connect the AC Adapter
Remove the protective material (first use only) before using the Label Printer.
Batteries
• When using the AC Adapter (AD-E001A):
- Insert the Adapter cord connector into the AC Adapter
Jack on the side of the printer.
- Insert the plug into the nearest standard electrical
socket. For memory backup, we recommend using AA
alkaline batteries (LR6) together with the AC Adapter.
• To safeguard and back up the Label Printer's memory,
when the AC Adapter is unplugged, keep AA alkaline
batteries (LR6) installed in the Label Printer.
• When power is disconnected for more than two minutes,
all text and format settings will be cleared. Any text files
stored in the memory will also be cleared.
• Remove the batteries if you do not intend to use the
Label Printer for an extended period of time.
• Dispose of the batteries at an appropriate collection
point, not in the general waste stream. In addition, be
sure to observe all applicable federal, state, and local
AC Adapter
regulations.
• When storing or discarding the batteries, wrap them
(for example with cellophane tape), to prevent them from
short-circuiting.
(Battery insulation example)
1. Cellophane tape
2. Alkaline battery
3. Insert the Tape Cassette
• After the tape passes under the Tape Guide, pull the tip
to remove any slack in the tape.
• Make sure the tape is not caught in the Label Printer
when inserting or removing the Tape Cassette.
1. Insert the Tape Cassette following the illustration under
the Tape Cassette Compartment Cover. Confirm that the
tip of the tape is pointed at the Tape Exit Slot.
2. Press the Tape Cassette into the Label Printer until
it locks into place, and then close the Tape Cassette
Compartment Cover.
4. Turn the Power ON or OFF
Power on Press
.
Press and hold
until the Label
Power off
Printer turns off.
2
1
Tape Guide
End of tape
To print from the Label Printer, go to
1. Print from the Label Printer
To print from your computer, go to
2. Print from Your Computer
To print from your mobile device, go to
3. Print from Your Mobile Device