Brother PT-D460BT 빠른 시작 매뉴얼 - 페이지 8
{카테고리_이름} Brother PT-D460BT에 대한 빠른 시작 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Brother PT-D460BT 9 페이지.
Brother PT-D460BT에 대해서도 마찬가지입니다: 매뉴얼 (9 페이지)
페이지 인쇄
Problem
Solution
The ink ribbon is separated
If the ink ribbon is broken, replace the Tape Cassette.
from the ink roller.
If it is not, leave the tape uncut and carefully remove
the Tape Cassette, and then wind the loose ink ribbon
back onto the spool.
Printed barcodes or
• Change the tape. (Recommended: Black on white tape)
QR codes cannot be read.
• Enlarge the barcodes or QR codes in the application you are using.
I do not know the firmware
Check the firmware information by pressing the following keys:
version of the Label Printer.
/
When the label is printed,
• When you use the [Small Margin] setting, the Label Printer feeds
there is too much margin
approx. 23 mm of tape before each label. To save tape, use the
(space) on both sides of
[Chain] setting. After the last label prints, press
the text.
the tape, and then press the Tape Cutter Lever.
• The Label Printer feeds approx. 23 mm of tape before every new
label. When printing multiple labels, you can reduce the blank space
on the second and subsequent labels.
Select the [Chain] setting in the optional print settings. Then, print
your labels and leave the last label in the Label Printer until you are
ready to print a new label.
• After the last label prints, press
the tape, and then eject and cut the last label. Note that the Label
Printer will feed approx. 23 mm of tape before the next new label
when you use this method.
The font size cannot be
The font is already the maximum size for the width of the label. Or, the
increased.
label length has been set, so there is a limit on the font size to prevent
exceeding the set length.
When multiple labels are
When Chain Print is enabled, feed the tape to eject the last printed
printed, the last label is cut
label, and then press the Tape Cutter Lever to cut the label manually.
incorrectly.
I cannot update the printer's
Restart the printer and then try to update the firmware again. Do not
firmware using the P-touch
press any buttons during the firmware update.
Update Software, Transfer
Express, or Mac Update Tool.
[Settings]
/
[Version Information]
and
simultaneously to feed
Contact Information
Visit www.brother.com for contact information on your local Brother office.
Spool
To order supplies and accessories:
www.brother.eu/supplies
and
to feed