Brother PT-E500 빠른 설정 매뉴얼 - 페이지 14

{카테고리_이름} Brother PT-E500에 대한 빠른 설정 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Brother PT-E500 46 페이지. Electronic labeling system
Brother PT-E500에 대해서도 마찬가지입니다: 운영자 매뉴얼 (6 페이지)

페이지 인쇄

INTRODUCTION

Rechargeable Li-ion battery

• At the time of purchase, the rechargeable Li-ion battery is slightly charged so that the

operation of the P-touch labeling system can be verified; however, the rechargeable Li-ion

battery should be fully charged with the AC adapter before the P-touch labeling system is

used.

• If the P-touch labeling system will not be used for a long period of time, remove the

rechargeable Li-ion battery from the P-touch labeling system, and then store it in a location

where it is not exposed to static electricity, high humidity, or high temperatures

(temperatures between 15°C and 25°C 40% to 60% humidity are recommended). In order

to maintain the efficiency and life of the Li-ion rechargeable battery, charge it at least every

six months.

• If you notice anything unusual about the rechargeable Li-ion battery the first time it is used,

for example overheating or rust, DO NOT continue to use the battery. Contact Brother

customer service.

P-touch Labeling System

• DO NOT install the P-touch labeling system near any device that will cause

electromagnetic interference. The P-touch labeling system may malfunction if left near a

television or radio etc.

• DO NOT use the P-touch labeling system in any way or for any purpose not described in

this guide. Doing so may result in injury or damage to the P-touch labeling system.

• DO NOT put any foreign objects into the tape exit slot, AC adapter connector, or any other

part of the P-touch labeling system.

• DO NOT touch the print head (see page 9) with your fingers. Use the optional print head

cleaning cassette (TZe-CL4) or a soft wipe (e.g.a cotton swab) when cleaning the print

head (see the User's Guide).

• DO NOT clean any part of the P-touch labeling system with alcohol or other organic

solvents. Only use a soft, dry cloth.

• DO NOT place the P-touch labeling system in direct sunlight, near heaters or other hot

appliances, or in any location exposed to extremely high or low temperatures, high

humidity, or dust. The standard operating temperature range of the P-touch labeling

system is 10°C to 35°C.

• DO NOT leave any rubber or vinyl, or products made of rubber or vinyl, on the P-touch

labeling system for an extended period of time, otherwise the P-touch labeling system may

become marked.

• Depending on the environmental conditions and the applied settings, some characters or

symbols may be difficult to read.

• Use only Brother TZe, HGe tapes or HSe tubes with the P-touch labeling system. Do not

use tapes that do not have the

• DO NOT pull or apply pressure to the tape in the cassette to avoid damaging the P-touch

labeling system.

• DO NOT try to print labels using an empty tape cassette or without a tape cassette in the

P-touch labeling system. Doing so will damage the print head.

• DO NOT attempt to cut the tape while printing or feeding since this will damage the tape.

• Depending on the location, material, and environmental conditions, the label may unpeel

or become irremovable, and the color of the label may change or be transferred to other

objects.

General Precautions

mark.