Brother PT-E500 운영자 매뉴얼 - 페이지 6

{카테고리_이름} Brother PT-E500에 대한 운영자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Brother PT-E500 6 페이지. Electronic labeling system
Brother PT-E500에 대해서도 마찬가지입니다: 빠른 설정 매뉴얼 (46 페이지)

페이지 인쇄

GETTING STARTED - AC Power Adapter

1. Connect AC Adapter

Plug the AC Adapter AD-E001 as shown above.

DO NOT USE ad-18 or AD24ES AC Adapters!

Plug the AC Adapter into a standard electrical outlet.

Installing the Rechargeable Li-ion Battery

1. Open the rear cover by pressing the cover latch.

1. Rear Cover

2. Cover latch

2. Insert the rechargeable

Li-ion battery

3. Confirm that the hooks on the edge

of the rear cover are inserted

correctly and then reattach the

cover.

Page – 4

GETTING STARTED - Alkaline Ni-MH Battery

1. Make sure the POWER IS OFF! Always replace all six batteries at the

same time using six brand new

fully charged batteries.

2. Remove the rear cover.

3. If the batteries are already in the P-

touch label printer, remove them.

4. Insert six new AA-size alkaline

batteries (LR6), or fully charged Ni-MH

rechargeable batteries (HR6), making

sure that the positive (+) and negative

(-) ends of the batteries match the

positive (+) and negative (-) marks

inside the battery compartment.

5. Visit http//solutions.brother.com/ for the

latest information about recommended

batteries.

6. Attach the rear cover by inserting

the three hooks at the bottom into

the slots on the P-touch label

printer, then pushing down firmly

until it snaps into place.

7. REMOVE THE BATTERIES IF YOU DO NOT INTEND TO USE THE

P-TOUCH FOR AN EXTENDED PERIOD OF TIME.

Page - 5