Brother PT-MT (P-touch mini ' tech) 서비스 매뉴얼 - 페이지 37
{카테고리_이름} Brother PT-MT (P-touch mini ' tech)에 대한 서비스 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Brother PT-MT (P-touch mini ' tech) 45 페이지.
Brother PT-MT (P-touch mini ' tech)에 대해서도 마찬가지입니다: 부품 참조 목록 (14 페이지)
페이지 인쇄
4) Counterclockwise turn the select dial slowly and check that the correct dial
position number will be displayed.
NOTE: Do not turn the select dial quickly or clockwise. Doing so cannot check the
dial operation correctly. If the select dial is set to any wrong position, "X" will
display as shown below. In the sample below, the select dial should be set to Dial
position 2 but now it is set to any other position. Turn the select dial to Dial
position 2 clockwise or counterclockwise.
5) After checking dial position 31, turn the select dial to the next position (Dial
position
), then "OK" will appear and "OK" will be printed.
6) Press the cutter lever and cut the tape.
CUT submode (Dial position 3 and Enter key*)
(*In any other submode, setting the select dial to Dial position 3 and pressing the Enter key
will jump to CUT submode, except during checking in DIAL submode.)
TIP: The cutter operation may be checked in any other submode, so you may skip
this CUT submode and proceed to PRINT1 submode. To skip the CUT submode,
turn the select dial to Dial position 4 and press the Enter key.
1) When "OK" is displayed, press the Enter key.
The machine shows the following and enters the CUT submode.
2) Press the Enter key.
While displaying the following, the machine will feed tape.
III - 22