Brother QL-1050 사용자 설명서 - 페이지 32

{카테고리_이름} Brother QL-1050에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Brother QL-1050 40 페이지. Label printer
Brother QL-1050에 대해서도 마찬가지입니다: 드라이버 매뉴얼 (27 페이지), 빠른 시작 매뉴얼 (2 페이지), 소프트웨어 사용 설명서 (40 페이지), 소프트웨어 사용 설명서 (48 페이지), 사양 시트 (2 페이지), 빠른 가이드 (2 페이지), 빠른 시작 매뉴얼 (2 페이지), 사용자 설명서 (48 페이지), 소프트웨어 설치 매뉴얼 (15 페이지)

Appendix

Fonts and several bar codes are embedded within this machine. You can send commands to print embedded

characters and barcodes. (For QL-580N/QL-1050/QL-1060N only)

Commands available are P-touch proprietary commands based on ESC/P.

For details, see the "Command Reference" included in the CD-ROM.

([CD Drive]:\Doc\Technical)

The pin assignments for the serial cables (RS-232C cables) which can be used with this machine are shown

in the table below. You can purchase the cables at an electronics store. Do not use an interface cable that is

longer than 2.0 meters (6 feet).

Brother QL side

(D-sub female, lock screw #4-40 inch screw)

Signal

Name

Number

DCD

RXD

TXD

DTR

GND

DSR

RTS

CTS

• It is not possible to connect RS-232C cable and USB cable to the printer at the same time and use it.

• Connect only one cable which is used to communicate with the printer. (For QL-1050 only)

• The RS-232C serial connector part of this equipment is not Limited Power Source.

Pin Assignments

Available Commands

PC side

(D-Sub9P female)

Signal

Number

Name

DCD

RXD

TXD

DTR

GND

DSR

RTS

CTS