Brother QL-1060N 네트워크 사용 설명서 - 페이지 29

{카테고리_이름} Brother QL-1060N에 대한 네트워크 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Brother QL-1060N 48 페이지. Label printer
Brother QL-1060N에 대해서도 마찬가지입니다: 네트워크 사용 설명서 (42 페이지), 사용자 설명서 (42 페이지), 소프트웨어 사용 설명서 (40 페이지), 소프트웨어 사용 설명서 (48 페이지), 네트워크 사용 설명서 (41 페이지), 사용자 설명서 (40 페이지), 사용자 설명서 (48 페이지), 사용자 설명서 (41 페이지), 사용자 설명서 (24 페이지)

Appendix B

Configuring your printer for a network

To use the printer in a networked TCP/IP environment, you need to configure its IP address and subnet mask.

The IP address you assign to the print server must be on the same logical network as your host computers.

If it is not, you must properly configure the subnet mask and the gateway address.

IP address

An IP address is a series of numbers that identifies each device connected to a network. An IP address

consists of four numbers separated by dots. Each number is between 0 and 255.



Example: In a small network, you would normally change the final number.

• 192.168.1.1

• 192.168.1.2

• 192.168.1.3

How the IP address is assigned to your print server:

If you have a DHCP/BOOTP/RARP server on your network the print server will automatically obtain its IP

address from that server.

Note

On smaller networks, the DHCP server may also be the router.

For more information on DHCP, BOOTP and RARP, see:

Using DHCP to configure the IP address uu page 29.

Using BOOTP to configure the IP address uu page 30.

Using RARP to configure the IP address uu page 29.

If you do not have a DHCP/BOOTP/RARP server, the Automatic Private IP Addressing (APIPA) protocol will

automatically assign an IP address from the range 169.254.1.0 to 169.254.254.255. For more information on

APIPA, see Using APIPA to configure the IP address uu page 30.