AEG L6FBG142R 사용자 설명서 - 페이지 25

{카테고리_이름} AEG L6FBG142R에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. AEG L6FBG142R 40 페이지.
AEG L6FBG142R에 대해서도 마찬가지입니다: 사용자 설명서 (36 페이지), 사용자 설명서 (44 페이지)

페이지 인쇄

The programme or the delay start

continues.

4. The door can be opened when the

programme is complete, or set

Drain/Spin programme and than

press Start/Pause button.

11.13 End of the programme

When the programme has finished, the

appliance stops automatically. The

acoustic signals operate (if they are

active).

In the display all washing phase

indicators become steady and the time

area shows .

The indicator of the Start/Pause button

goes off.

The door unlocks and the indicator

goes off.

1. Press the On/Off button to

deactivate the appliance.

After five minutes from the end of the

programme, the energy saving function

automatically deactivates the appliance.

When you activate the

appliance again, the display

show the end of the last

selected programme. Turn

the programme dial to set a

new cycle.

2. Remove the laundry from the

appliance.

3. Make sure that the drum is empty.

4. Keep the door and the detergent

dispenser slightly ajar to prevent

mildew and odours.

5. Close the water tap.

11.14 Draining water out after

end of cycle

If you have chosen a programme or an

option that does not empty out the

water of the last rinse, the programme is

completed, but:

• The display shows the indicator , the

option indicator

door locked indicator

and the

. The

indicator of the running phase

flashes.

• The drum still turns at regular intervals

to prevent the creases in the laundry.

• The door stays locked.

• You must drain the water to open the

door:

1. If necessary, touch the Spin button to

decrease the spin speed proposed

by the appliance.

2. Touch the Start/Pause button:

• If you have set

drains the water and spins.

• If you have set

only drains the water.

The option indicator

while the indicator

goes off.

3. When the programme is completed

and the door locked indicator

goes off, you can open the door.

4. Press the On/Off button a few

seconds to deactivate the appliance.

In any case, the appliance

empties the water out

automatically after

approximately 18 hours.

11.15 Stand-by option

The Stand-by function automatically

deactivates the appliance to decrease

the energy consumption when:

• You do not use the appliance for 5

minutes before you touch the Start/

Pause button.

Press the button On/Off to activate

the appliance again.

• After 5 minutes from the end of the

washing programme

Press the On/Off button to activate

the appliance again.

The display shows the end of the last

set programme.

Turn the programme dial to set a new

cycle.

If you set a programme or an

option that ends with water

in the drum, the Stand-by

function doesn't deactivate

the appliance to remind you

to drain the water.

ENGLISH

, the appliance

goes out,

flashes and then