Brother TD-4100N 네트워크 사용 설명서 - 페이지 33

{카테고리_이름} Brother TD-4100N에 대한 네트워크 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Brother TD-4100N 39 페이지. Network users manual - spanish
Brother TD-4100N에 대해서도 마찬가지입니다: 기술 사양 (4 페이지), 소프트웨어 사용 설명서 (40 페이지), 사용자 설명서 (36 페이지), 사용자 설명서 (37 페이지), 매뉴얼 (20 페이지), (스페인어) 구 (40 페이지), (스페인어) 매뉴얼 델 유저리오 (39 페이지)

Appendix A

Using the Telnet console to configure the IP address

You can also use the Telnet command to change the IP address.

Telnet is an effective method to change the printer's IP address. But a valid IP address must already be

programmed into the print server.

Type TELNET IP address at the command prompt of the system prompt, where ipaddress is the IP address

of the print server. When you are connected, push the Return or Enter key to get the "#" prompt, enter the

password access (the password will not appear on the screen).

You will be prompted for a user name. Enter anything in response to this prompt.

You will then get the Local> prompt. Type SET IP ADDRESS ipaddress, where ipaddress is the

desired IP address you wish to assign to the print server (check with your network administrator for the IP

address to use). For example:

Local> SET IP ADDRESS 192.168.1.3

You will now need to set the subnet mask by typing SET IP SUBNET subnet mask, where subnet mask

is the desired subnet mask you wish to assign to the print server (check with your network administrator for

the subnet mask to use). For example:

Local> SET IP SUBNET 255.255.255.0

If you do not have any subnets, use one of the following default subnet masks:

255.0.0.0 for class A networks

255.255.0.0 for class B networks

255.255.255.0 for class C networks

The leftmost group of digits in your IP address can identify the type of network you have. The value of this

group ranges from 1 through 127 for Class A networks (e.g., 13.27.7.1), 128 through 191 for Class B networks

(e.g.,128.10.1.30), and 192 through 255 for Class C networks (e.g., 192.168.1.4).

If you have a gateway (router), enter its address with the command SET IP ROUTER routeraddress,

where routeraddress is the desired IP address of the gateway you wish to assign to the print server. For

example:

Local> SET IP ROUTER 192.168.1.4

Type SET IP METHOD STATIC to set the method of IP access configuration to static.

To verify that you have entered the IP information correctly, type SHOW IP.

Type EXIT or CTRL-D (i.e., hold down the control key and type "D") to end the remote console session.