Brother TJ-4620TN 설정 매뉴얼 - 페이지 2

{카테고리_이름} Brother TJ-4620TN에 대한 설정 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Brother TJ-4620TN 4 페이지. Label peeler module

4. Remove the Black Cap. Install the Roller Module in the slot, and fix the Screw

as illustrated (fastened by 0.74 N • m ± 0.10 N • m), and then insert the Black

Cap back into the slot.

NOTE

You must tighten the Screw to prevent the Roller Module from dislodging

when the Label Peeler is in use.

5. Make sure the AC Power Cord is disconnected from the AC power outlet

(electrical socket), and then plug the Label Peeler Module Cable into the Cable

Socket.

NOTE

• Secure the cable by affixing the Adhesive Hook onto the PCB side.

• DO NOT force the cable into the socket.

• Make sure you align the Label Peeler Module Cable's Connector with the

Cable Socket before plugging the Label Peeler Module Cable, as

illustrated.

6. Mount the Peeler Module by inserting both bolts into the Mounting Holes, as

illustrated.

7. Fasten the two Fixing Bolts and two Screws to secure the Label Peeler

Module, and then close the module's Front Cover (fastened by 0.74 Nɾm ±

0.10 Nɾm).