Fujitsu T5010 - LifeBook Tablet PC 바이오스 매뉴얼 - 페이지 22
{카테고리_이름} Fujitsu T5010 - LifeBook Tablet PC에 대한 바이오스 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Fujitsu T5010 - LifeBook Tablet PC 29 페이지. Rubber base cover
Fujitsu T5010 - LifeBook Tablet PC에 대해서도 마찬가지입니다: 시작하기 (2 페이지), 데이터시트 (6 페이지), 사용자 설명서 (8 페이지), 시작하기 (13 페이지), 복원 매뉴얼 (2 페이지), 지침 (4 페이지)
페이지 인쇄
L i f e B o o k T S e r i e s B I O S
Hard Disk Security Submenu of the Security Menu
The Hard Disk Security submenu is for configuring hard disk security features.
Info
Drive0:
* Set Master Password
* Set User Password
Drive1:
Set Master Password
Set User Password
Password Entry on Boot:
* Hard Disk Password cannot be set or changed if
the system is rebooted from OS. Choose "Save
Changes and Power Off" in Exit Menu to shut
down the system, then Hard Disk Password
can be set or changed on next boot.
F1
Help
ESC
Exit
Table 15: Fields, Options and Defaults for the Hard Disk Security Submenu of the Security Menu
Menu Field
Options
Drive0:
___
Set Master
___
Password
Set User
___
Password
Drive1:
___
22
Phoenix SecureCore(tm) Setup Utility
System
Advanced
Hard Disk Security
Select Item
-/Space
Select Menu
Enter
Figure 15. Hard Disk Security Submenu
Default
Description
Clear
Display-only. Default is Clear. When the Drive0 Password has been set, the field
changes to Set. When this password is set, the primary hard disk drive cannot be
used in another system unless the password is entered.
[Enter]
Sets, changes or cancels the Drive0 Master Password. The Drive0 Master Password
may be up to seven characters long and must include only letters or numbers (no
symbols). Passwords are NOT case-sensitive. When a Drive0 Password is set, it must
be used to access the hard drive if it is used in another system. Note that the pass-
word will not take effect until the system has been rebooted.
[Enter]
Sets, changes or cancels the Drive0 User Password. The Drive0 User Password may
be up to seven characters long and must include only letters or numbers (no sym-
bols). Passwords are NOT case-sensitive. When a Drive0 Password is set, it must be
used to access the hard drive if it is used in another system. Note that the password
will not take effect until the system has been rebooted.
Clear
Display-only. Default is Clear. When the Drive1 Password has been set, the field
changes to Set. When this password is set, the primary hard disk drive cannot be
used in another system unless the password is entered. When only one drive is
installed (Drive 0:), [Not available] appears here.
Security
Boot
Clear
[Enter]
[Enter]
Not Available
[Enter]
[Enter]
[Enabled]
Change Values
Select
Sub-Menu
Exit
Item Specific Help
F9
Setup Defaults
F10
Save and Exit