Brother DCP-110C 빠른 설정 매뉴얼 - 페이지 6

{카테고리_이름} Brother DCP-110C에 대한 빠른 설정 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Brother DCP-110C 35 페이지. Facsimile equipment
Brother DCP-110C에 대해서도 마찬가지입니다: 빠른 설정 매뉴얼 (24 페이지), 빠른 구성 수동 설정 (24 페이지), 부품 참조 목록 (30 페이지)

페이지 인쇄
Brother DCP-110C 빠른 설정 매뉴얼

Step 1

Removing the Protective
1
Parts
1
Remove the protective tape.
DO NOT connect the USB cable.
Connecting the USB cable is done
when installing the driver.
Attaching the Control
2
Panel
1
Attach the control panel to the machine.

Loading Paper

3
You can load up to 100 sheets of 80 g/m
paper.
For more details, see "About paper" in
Chapter 1 of the User's Guide.
1
Pull the paper tray completely out of the
machine and remove the output paper tray.
4

Setting Up the Machine

2
Press and slide the paper guide to fit the
paper width.
Paper Side Guide
3
Pull out the paper support and unfold the
paper support flap.
Paper Support Flap
Use the paper support flap for Letter, Legal
and A4 size paper.
4
Fan the stack of paper well to avoid paper
jams and mis-feeds.
5
Gently insert the paper into the paper tray
print side down and top edge first.
Check that the paper is flat in the tray and
2
below the maximum paper mark.
■ Make sure the paper side guides touch
the sides of the paper.
■ Be careful that you do not push the paper
in too far; it may lift at the back of the tray
and cause paper feed problems.
6
Put the output paper tray back on and push
the paper tray firmly back into the machine.
Paper Support