Fujitsu BR5450 빠른 시작 매뉴얼 - 페이지 6
{카테고리_이름} Fujitsu BR5450에 대한 빠른 시작 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Fujitsu BR5450 22 페이지. Blade server systems, fibre channel connection blade
페이지 인쇄About Embedded Switch Module configuration
Use procedures in this chapter to configure the Embedded Switch Module to operate on a network and fabric. Also
use steps to change the Embedded Switch Module's operating mode (Fabric OS Native and Access Gateway modes).
NOTE
Although the Embedded Switch Module is configured at the factory for Fabric OS Native mode, you can enable it for
Access Gateway mode. For more information, refer to
page 17
This chapter provides configuration procedures that use Embedded Switch Module Command Line Interface (CLI)
and the Web Tools application. For details refer to the Web Tools Administrator's Guide, Access Gateway
Administrator's Guide, and Fabric OS Command Reference Manual. If the same operation can be performed using
the PRIMERGY BX900 Management Blade application, use that application instead.
Items required for configuration
The following items are required for configuring and connecting the Embedded Switch Module for use in a network
and fabric:
•
The Embedded Switch Module installed in a Blade Server chassis. For instructions, refer to the steps on
installing an I/O module in the PRIMERGY BX900 S1 Basic Unit Operating Manual for the Blade Server chassis.
•
Access to an FTP server for backing up the Embedded Switch Module configuration.
•
Access to these publications:
•
PRIMERGY BX900 S1 Basic Unit Operating Manual
•
PRIMERGY BX900 S1 Basic Unit Service Supplement
•
PRIMERGY BX900 Management Blade User Guide
•
Fabric OS Command Reference Manual
•
Fabric OS Administrator's Guide
•
Access Gateway Administrator's Guide
•
Web Tools Administrator's Guide
•
SFP transceivers and compatible fiber cables, as required.
•
If DHCP is not used to set the Embedded Switch Module IP address, you will need an unused IP address and a
corresponding subnet mask and gateway address. DHCP-enabled is the default.
•
If the PRIMERGY BX900 Management Blade GUI or CLI management is not used to change the Embedded
Switch Module IP address, you will need a management workstation (computer) that has a terminal emulator
(such as HyperTerminal) or a keyboard, video, and mouse (KVM) device. You will also need a serial cable to
connect the workstation to the Embedded Switch Module serial console port.
Brocade 5450 Embedded Switch Module QuickStart Guide
Publication Number: 53-1001265-02
"Changing from Fabric OS Native to Access Gateway mode"
on
5 of 20