Fujitsu BS2000 SE300 매뉴얼 - 페이지 5

{카테고리_이름} Fujitsu BS2000 SE300에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Fujitsu BS2000 SE300 42 페이지. Server unit x86
Fujitsu BS2000 SE300에 대해서도 마찬가지입니다: 운영 매뉴얼 (22 페이지)

페이지 인쇄

1 Introduction

The FUJITSU Server BS2000 SE Series unites the existing server lines S servers and SQ

servers in the server line SE servers.

Depending on requirements, the SE server contains all the system components needed for

operation as an overall application:

–

/390-based BS2000 Server Unit

–

x86-based Server Units with BS2000, Linux or Windows guest systems

–

x86-based Application Units for operation under Linux, Windows or VMware

–

Shareable tape and disk periphery

–

A high-speed, server-internal infrastructure to connect the components with each other

and with the customer LAN or SAN.

Information on using the Quick Guide

This Quick Guide is intended for people who operate an SE server and contains short

instructions for the most important scenarios when placing the SE server in service. The

following requirements should be met:

Customer Support provides the customer with the SE server.

●

The desired BS2000 operating mode is set on each Server Unit.

●

A BS2000 system is configured and fully operational.

●

All necessary BS2000 devices are configured.

●

U41857-J-Z125-2-76

Please note the following:

The base system of the MU (M2000) as well as the iRMC of the MU have a pre-

defined administrator account admin at the time the SE server is delivered. In both

cases an initial password is preset, which you can ask for at the service.

Change the password immediately after you have logged in for the first time.

You may also change the validity time and the other password attributes.

You can access the password management as follows:

in SE Manager: Authorizations → User → Password management

–

on the iRMC: User management → iRMC S4 users

–