Fujitsu PRIMEPOWER 2500 하드웨어 플랫폼 매뉴얼 - 페이지 11

{카테고리_이름} Fujitsu PRIMEPOWER 2500에 대한 하드웨어 플랫폼 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Fujitsu PRIMEPOWER 2500 50 페이지. Enterprise servers
Fujitsu PRIMEPOWER 2500에 대해서도 마찬가지입니다: 매뉴얼 (21 페이지)

페이지 인쇄
Fujitsu PRIMEPOWER 2500 하드웨어 플랫폼 매뉴얼
7.
Press the Eject button on the diskette drive unit, then eject the diskette.
WARNING messages of se driver
When a serial port receives a lot of data, such as when a large amount of text is pasted on a console screen
connected to a serial port, the console message "seN: Buffer overrun" (N means an instance number of se
driver) will be displayed and the data will be lost.
This is because the user process cannot read data fast enough.
The size of data pasted on a console screen should be 1024 bytes or less at a time.
Speed of reception depends on each user process.

1.2.3 Notes on PCI cards

How to install PCI cards
To install a new PCI card, follow the steps described below.
Also, when you remove the PCI card or change the slot, do the following steps.
For PRIMEPOWER 1
1.
Enter the OpenBoot environment.
# /usr/sbin/shutdown -y -g0 -i0 <Return>
2.
Enter the following command to stop the system in the OpenBoot environment at the next system
boot.
ok setenv auto-boot? false <Return>
3.
Turn off the power to the system.
ok power-off <Return>
4.
Install the PCI card to the system. (For more detailed information, refer to the manual attached to
the card.)
5.
After you turn on the power, the OK prompt will be displayed. Boot the system with the following
command.
ok setenv auto-boot? true <Return>
ok boot -r <Return>
Some of the PCI cards need driver software. If that is the case, use the following steps:
6.
Add driver software. (For more detailed information, refer to the manual attached to the card.)
7.
Enter the Open Boot Environment. Some of the manuals attached to the card may instruct "Reboot
your machine", which means to enter the Open Boot Environment with the following command.
# /usr/sbin/shutdown -y -g0 -i0 <Return>
8.
When the OK prompt is displayed, boot the system with the following command.
ok boot -r <Return>
For PRIMEPOWER 200/400/600
1.
If the system is running, turn off the power to the system with the following command:
# /usr/sbin/shutdown -y -g0 -i5 <Return>
2.
Install the PCI card to the system. (For more detailed information, refer to the manual attached to
the card.)
3.
Set the MODE switch on the operation panel to "MANUAL" mode and turn on the power.
4.
After you turn on the power, the OK prompt will be displayed. Boot the system with the following
command.
ok boot -r <Return>
5.
Return the MODE switch on the operation panel to "SECURE" mode.
Some of the PCI cards need driver software. If that is the case, use the following steps:
6.
Add driver software. (For more detailed information, refer to the manual attached to the card.)
5