Fujitsu PRIMEPOWER 2500 하드웨어 플랫폼 매뉴얼 - 페이지 35

{카테고리_이름} Fujitsu PRIMEPOWER 2500에 대한 하드웨어 플랫폼 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Fujitsu PRIMEPOWER 2500 50 페이지. Enterprise servers
Fujitsu PRIMEPOWER 2500에 대해서도 마찬가지입니다: 매뉴얼 (21 페이지)

페이지 인쇄

The support ranges of takeover form are the following ranges.

PRIMECLUSTER

MAC

IP+ MAC

Caution

Using over operation management LAN (LAN used for cluster operation management view) cannot be

supported.

4.5.2 Cluster Environment Setup Procedure

Set up the cluster environment in the same way as for the other LAN driver, follow "Setting up the

Network" in the "PRIMECLUSTER manual". Note that the secondary LAN port (fjgi interface) resource

name is "fjgi".

4.5.3 Notes in Cluster Environment

Please use "PRIMECLUSTER 4.1 or later" for a cluster system to use fjgi interface. If an earlier version of

cluster system is used, fjgi interface cannot be used for private LAN nor for IP address fail-over on public

LAN.

When using fjgi interface as the cluster interconnect, please perform the following command before initial

composition setup.

# ifconfig fjgi* plumb <Return>

* is instance-number

Then, please execute the following command and check that a MTU size of fjgi interface is not 9000byte

(JumboFrame is not set up).

# ifconfig fjgi* <Return>

* is instance-number

GigabitEthernet in a JumboFrame function cannot be used to the cluster interconnect.

GigabitEthernet as VLAN interface cannot be used to the cluster interconnect.

1:n operation standby mode

Mutual standby mode

TCP/IP communication

Using to the cluster interconnect (PRIMECLUSTER). (But, using in a JumboFrame or as

VLAN interface can not be performed)

Taking over form

Support

Not Supported

(Supported V4.1A10 or later)

Not Supported

(Supported V4.1A10 or later)