Fujitsu PRIMEPOWER 650 하드웨어 플랫폼 매뉴얼 - 페이지 21

{카테고리_이름} Fujitsu PRIMEPOWER 650에 대한 하드웨어 플랫폼 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Fujitsu PRIMEPOWER 650 50 페이지. Mid-range, rack-mounted server
Fujitsu PRIMEPOWER 650에 대해서도 마찬가지입니다: 기술 백서 (19 페이지)

페이지 인쇄

Chapter 4 Secondary LAN port on

PRIMEPOWER250/450

This chapter describes how to use the secondary LAN (10/100/1000Mbps) port on PRIMEPOWER250/450.

4.1

Outline

The secondary LAN port on PRIMEPOWER250/450 is controlled by FUJITSU PCI Gigabit Ethernet

Driver (Interface name is "fjgi") included in Solaris 10.

4.2

Notes

When using 1000 Mbps communication, be sure to set Autonegation to 'on'.

If using the PCI card (PW008GE4/PW008GE5/PW008QG1), please refer to the User's guide attached

with the PCI card.

4.3

How to Set Configuration Information

This section describes required setting to use a fjgi interface.

4.3.1 Environment Setting

This section describes how to edit files required to build environment.

4.3.1.1

Determining the Client Name of Target Driver

To use the secondary LAN port as an IPv4 interface:

To allocate the IP address or hostname to the fjgi interface, edit /etc/hostname.fjgi* (* is an numerical

value) file. About netmask value, please see "4.3.1.3 Defining Netmask Value" .

Example /etc/hostname.fjgi*:

Define the unique hostname:

giga-v4

or, define the IP address:

192.168.150.1

Note: If you defined the hostname in hostname.fjgi* file, see the section "4.3.1.2 Defining Hostname "

for detailed information.

To use the secondary LAN port as an IPv6 interface

To allocate the IP address and prefix to the fjgi interface, edit /etc/hostname6.fjgi* (* is an numerical

value) file.