Fujitsu PRIMEPOWER 800 하드웨어 플랫폼 매뉴얼 - 페이지 7

{카테고리_이름} Fujitsu PRIMEPOWER 800에 대한 하드웨어 플랫폼 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Fujitsu PRIMEPOWER 800 50 페이지. Operation for solaris 10 operating system

Chapter 1 Notes after the Installation

This chapter describes the post-installation notes.

1.1

1.1.1 Modifications of Solaris OS (Patches, PTF, Program Local

Fix)

Only the modifications (patches, PTF, Program Local Fix, etc.) for PRIMEPOWER provided by FUJITSU

LIMITED can be applied to existing PRIMEPOWER systems running Solaris OS software.

Do not use patches provided by Sun Microsystems, Inc. on the World Wide Web or those provided by other

vendors. Also be careful that you do not apply modifications (patches, PTF, Program Local Fix, etc.)

intended for other systems (GP7000D, etc.) provided by FUJITSU LIMITED.

For information on Solaris OS modifications, contact a FUJITSU systems engineer.

PRIMEPOWER 1/200/250/400/450/600/650/850

Use the date command in single user mode if you need to change the date and time for testing purposes.

PRIMEPOWER 800/900/1000/1500/2000/2500

See "System Console Software User's Guide" for information on how to change the date and time.

1.1.3.1

All serial ports on the system board are to be used for the System Management Console.

Do not access the following devices relating to serial ports. Also do not change the setting of

applications using the following device files (such as a port monitor).

However, devices that are not used as the console path may be used, but only for the FJVTS and

SunVTS. The usable default devices for FJVTS and SunVTS are /dev/term/fa003, fa004, ... and

/dev/se_hdlc3, se_hdlc4, ...

1.1.3.2

The device name of the serial port will be as follows:

/dev/term/a, b, ...

/dev/cua/a, b, ...

/dev/term/fa000, fa001, ...

/dev/cua/fa000, fa001, ...

/dev/se_hdlc

/dev/se_hdlc0, /dev/se_hdlc1, ...