Fujitsu PRIMERGY 10/40GbE 사용자 설명서 - 페이지 13

{카테고리_이름} Fujitsu PRIMERGY 10/40GbE에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Fujitsu PRIMERGY 10/40GbE 23 페이지. Connection blade 18/8+2

페이지 인쇄

Backup by TFTP server can be done as following. (On the assumption that TFTP server is already prepared.)

#copy△config1△tftp://<tftp server IP address>/<file name>

This command example shows storing config1 as the name of <file name> to TFTP sever.

Restore by TFTP server can be done as following. (On the assumption that TFTP server is already prepared.)

#copy△tftp://<tftp server IP address>/<file name>△config1

......

#reset△config1

This command example shows downloading <file name> from TFTP server as config1. Then reset the

switch by assigning next-boot configuration file

Restring the configuration by FTP/TFTP needs the switch reboot.

2.7.5

Clearing Configuration

Clearing the configuration can be done by reset clear command.

#reset△clear

2.8 Updating Firmware

Updating Firmware can be done by FTP as the following procedures.

(This example is on Window OS command prompt.)

C:<config>ftp△192.168.1.10

User (192.168.1.100:(none)): admin

331 Password required for admin.

Password:admin

230 User admin logged in.

ftp> bin

200 Type set to I

ftp> put△SBAX3V0XXXBIND_NYXX_NJXX△bindfirm

・

226 Write complete

2856 bytes sent in 1.10 seconds (2.44 Kbytes/s)

ftp>get△reset

・

ftp>bye

The new firmware is applied after reset.

In case of TFTP, updating firmware can be done as the following.

#copy△tftp://<tftp server IP address>/<f/w file name>△switch_firm

......

#reset

PRIMERGY 10/40GbE Connection Blade 18/8+2 User Guide

#Connect with FTP to Connection Blade

#Enter User Name

#Enter Password

#Change to binary mode

#Update firmware

#Restart connection blade

#exit FTP access

Page 13 / 23

#Update firmware

#reboot