Fujitsu PRIMERGY BX600 수동 시작 - 페이지 6

{카테고리_이름} Fujitsu PRIMERGY BX600에 대한 수동 시작을 온라인으로 검색하거나 PDF를 다운로드하세요. Fujitsu PRIMERGY BX600 13 페이지.

페이지 인쇄

n Setting Switch Blade

Perform default settings such as password for each installed Switch Blade. For details, refer to "PRIMERGY

BX600 LAN Switch Blade Document CD".

Do not set VLAN at this time.

n Setting Server Blade

Power on the server blade, and perform settings for the BIOS Setup Utility as required. Set for each installed

blade.

��

"Chapter 8 Hardware Configuration/Utilities"

Before powering on, be sure to check that the CD-ROM drive and floppy disk drive are connected to the server blade where

software will be installed, and that a display is connected to the chassis.

lBIOS Setup Utility

Change the settings in the following cases:

- When changing a drive which boots up this server

- When performing remote installation

- When optional devices are installed

You can write down hardware configuration and setting

values of the BIOS Setup Utility in the

Sheets

that is available from Fujitsu PRIMERGY website

(http://primergy.fujitsu.com).

Prepare the ServerStart CD-ROM.

Turn on the server blade, and insert the

ServerStart Disc1 CD-ROM immedi-

ately.

1. Press the power switch of the server blade.

��

Press the CD-ROM eject button (OPEN), and

insert the ServerStart Disc1 CD-ROM.

Configuration

��

Set the hardware.

If no hardware settings are performed, skip to the

next step when a message to insert the ServerStart

floppy disk is displayed.

l BIOS Setup Utility

1. If the "Press F2 to run Setup" message

appears during server startup (during POST),

press [F2] while the message is being

displayed.

2. Check/change the BIOS settings.

3. Select "Save Changes & Exit" from the Exit

menu and press [Enter].

4. Move the cursor to "Yes" using [←] [→] and

press [Enter].

For the use of Linux distribution with this server,

refer to the Fujitsu PRIMERGY website (http://

primergy.fujitsu.com).