Fujitsu PRIMERGY BX900 S1 서비스 보충 설명서 - 페이지 13

{카테고리_이름} Fujitsu PRIMERGY BX900 S1에 대한 서비스 보충 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Fujitsu PRIMERGY BX900 S1 46 페이지.

CAUTION!

The ON/OFF button does not disconnect the device from the mains

voltage. To disconnect the line voltage completely, remove all power

plugs from the grounded insulated sockets.

Always connect the device and the attached peripherals to the same

power circuit. Otherwise you run the risk of losing data if, for example,

the central processing unit is still running but the peripheral device

(e.g. storage subsystem) has failed during a power outage.

Data cables to peripheral devices must be adequately shielded.

To the LAN wiring the requirements apply in accordance with the

standards EN 50173 and EN 50174-1/2. As minimum requirement

the use of a protected LAN line of category 5 for 10/100 Mbit/s

Ethernet, and/or of category 5e for Gigabit Ethernet is considered.

The requirements of the specification ISO/IEC 11801 are to be

considered.

Route the cables in such a way that they do not form a potential

hazard (make sure no-one can trip over them) and that they cannot

be damaged. When connecting up a device, refer to the relevant

notes in this manual.

Never connect or disconnect data transmission lines during a storm

(lightning hazard).

Make sure that no objects (such as bracelets or paper clips) fall into

or liquids spill into the device (risk of electric shock or short circuit).

In emergencies (e.g. damaged casing, controls or cables, penetration

of liquids or foreign matter), switch off the device immediately, remove

the power plug and contact your sales outlet or customer service

team.

Proper operation of the device (in accordance with IEC 60950/

EN 60950) is only ensured if the casing is completely assembled and

the rear covers for the installation openings have been put in place

(electric shock, cooling, fire protection, interference suppression).

BX900 S1

Service Supplement

Safety notes