Fujitsu PRIMERGY Econel 200 S2 서비스 보충 설명서 - 페이지 17
{카테고리_이름} Fujitsu PRIMERGY Econel 200 S2에 대한 서비스 보충 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Fujitsu PRIMERGY Econel 200 S2 39 페이지.
페이지 인쇄
4
Replacement routines
V
CAUTION!
Refer to the safety notes in
4.1
Preparation
I
You will find a detailed description with photos in the Econel 200 S2
Options Guide.
4.1.1
Opening the server
Ê Terminate all applications and shut down the server correctly.
Ê If your operating system has not switched off the server, press the on/off
button.
Ê Remove the power plug from the grounded insulated socket.
Ê If required, remove the lock on the side cover.
Ê Open the latch.
The opening of the latch pushes back the side cover and disengage the
hooks on the top of the side cover.
Ê Remove the side cover.
4.1.2
Removing the processor fan 2
Ê Remove the side cover as described in section "Opening the server" on
page 17.
Ê Disconnect the plug of the processor fan cable from the system board
(connector Fan2 CPU, see system board foil D2530).
Ê Press together the two locks of the air duct, use the grip at the right side and
remove the air duct with the integrated processor fan 2.
Econel 200 S2
chapter "Safety notes" on page 11
Service Supplement
et seq. .
17