Fujitsu PRIMERGY Econel 200 S2 서비스 보충 설명서 - 페이지 28

{카테고리_이름} Fujitsu PRIMERGY Econel 200 S2에 대한 서비스 보충 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Fujitsu PRIMERGY Econel 200 S2 39 페이지.

페이지 인쇄
Fujitsu PRIMERGY Econel 200 S2 서비스 보충 설명서
Replacing the power supply unit
Figure 12: Inserting the power supply unit
Ê Push the power supply unit in direction of the server's rear side until it
engages in the chassis.
Ê Fasten the power supply unit with four screws on the server's rear side (see
figure 9 on page 26).
Ê Route the power cables in the same way as for the old power supply unit.
I
If the spare power supply unit is equipped with a cable clamp (as in
figure 10) it is possible to retain the cables in the shown way. Otherwise
route the cables where you find enough free space.
Ê Connect the power supply cables to the system board and to the drives (see
cabling in the Options Guide).
Ê Install the memory air duct (for a detailed description see the Options
Guide).
Ê Install the system fan (for a detailed description see the Options Guide).
Ê Install the processor fan 2 (for a detailed description see the Options Guide).
Ê Close the server (for a detailed description see the Options Guide) and
connect the power plug.
28
Service Supplement
Replacement routines
Econel 200 S2