Fujitsu PRIMERGY RX200 S2 빠른 시작 매뉴얼 - 페이지 2

{카테고리_이름} Fujitsu PRIMERGY RX200 S2에 대한 빠른 시작 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Fujitsu PRIMERGY RX200 S2 8 페이지.

페이지 인쇄

Checking location before installing the server

For details on installing the rack, refer to the "Installation

Guide for the RACK" and the manual provided with the

rack.

nConditions

When installing this server avoid the following areas.

- Humid, dusty, or oily areas

- Poorly ventilated areas

- Areas close to fire or other sources of heat

- Areas close to water

- A reas close to direct sunlight or near heating

appliances

- Areas with a temperature of below 10°C or above 35°C

- Areas with humidity of less than 20% or more than

80%

- Salty areas

- Areas where corrosive gas is generated

- Areas where cables become trip hazards

- Areas where strong magnetic fields are generated,

such as near TVs and speakers

- Areas where the device is not stable and could tip

over and hurt somebody

- In dusty area, dust will quickly stick to the front and back-

side of the server. Since this can cause failure, changing

the installation place is recommended.

- Noise level of this server is measured at 63dB. It is rec-

ommended to place the server in an exclusive room. Use

the server with care if it is placed in an office.

- Be sure to secure racks and connect stabilizers to pre-

vent the device tipping over.

nInstalling the server to the rack

Open both the front and rear doors of

the rack.

Pull out the inner rail from the slide

rail.

��

Attach the inner rails on the right and

left side of the server.

��

Loosen the rear slide rail screws.

��

Attach the slide rails to the right and

left of the rack.

1. Attach the slide rails to the first and the

third holes from the bottom of the server.

��

2. Tightly fasten the loosened rear slide rail

screws.

��