Fujitsu PRIMERGY RX200 S3 서비스 보충 설명서 - 페이지 21

{카테고리_이름} Fujitsu PRIMERGY RX200 S3에 대한 서비스 보충 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Fujitsu PRIMERGY RX200 S3 49 페이지.
Fujitsu PRIMERGY RX200 S3에 대해서도 마찬가지입니다: 수동 시작 (8 페이지)

페이지 인쇄
Fujitsu PRIMERGY RX200 S3 서비스 보충 설명서
Replacing components
Figure 6: Removing the control panel kit
Ê Pull out the control panel kit toward you.
To install the control panel kit follow the above steps in reverse.
4.5
Replacing the chassis ID / temperature
sensor
In this server, the chassis ID/temperature sensor is located on the control panel
board. Therefore, to replace the chassis ID/temperature sensor, you must
replace the entire control panel kit (see
on page
20).
I
To enable ServerView and ServerStart to identify the system, the chassis
ID prom must be reprogrammed with the ChassisIDProm tool after the
new control panel board has been installed.
The tool can be found on the ServerSupport CD or downloaded from the
Fujitsu Siemens Computers service and support area on the Internet
(http://extranet.fujitsu-siemens.com/service/information/intelservers/tools).
RX200 S3

Replacing the chassis ID / temperature sensor

section "Replacing the control panel kit"
Service Supplement
21