Fujitsu Primergy RX200 S4 수동 시작 - 페이지 3

{카테고리_이름} Fujitsu Primergy RX200 S4에 대한 수동 시작을 온라인으로 검색하거나 PDF를 다운로드하세요. Fujitsu Primergy RX200 S4 9 페이지.
Fujitsu Primergy RX200 S4에 대해서도 마찬가지입니다: 서비스 보충 설명서 (39 페이지)

페이지 인쇄

Install the server in the rack.

��

Insert the inner rails attached to the server

straight on the grooves in the slide rails.

Do not push the inner rails into the slide rails by

force. Fittings of the inner rails may be trans-

formed, and the rails do not move normally.

Release the locks on both sides of the inner

rails (press up for the right side and press

down for the left side), and slide the server

backward slowly to install it in the rack.

Connecting peripheral devices

Peripheral devices, such as the keyboard and mouse, etc., are connected to the server in the following

order. Install wiring leaving plenty of slack for when operating the server while it is pulled out from the

rack.

Use the release tie to secure the cables that were connected to prevent them from falling.

nCable forming process

After connecting the peripheral devices, tie all the cables and fix them with the release tie to the cable holder provided with

the rack.

This forming process makes the cables easily recognizable even when multiple servers are installed in the rack.

��

Be careful not to pinch your fingers or catch any

clothing when sliding the server into the cabinet.

This could cause injury.

Secure the server to the rack.

Install the attached blank panel to the rack, where

the server or peripheral devices are not installed.

��

Release tie

�